Modular Mining Systems Inc 301582 User Manual
FCC ID: FJ6-301582
MFA p0130004, d0170002
(The following will be placed in the Instruction Manual)
MANDATORY SAFETY INSTRUCTIONS TO INSTALLERS & USERS
Use only manufacturer or dealer supplied antenna.
Antenna Minimum Safe Distance: 20 cm .
Antenna Gain: zero dBd referenced to a dipole.
The Federal Communications Commission has adopted a safety standard
for human exposure to RF (Radio Frequency) energy which is below
the OSHA (Occupational Safety and Health Act) limits.
for human exposure to RF (Radio Frequency) energy which is below
the OSHA (Occupational Safety and Health Act) limits.
Antenna Mounting:
The antenna supplied by the manufacturer or
radio dealer must not be mounted at a location such that during
radio transmission, any person or persons can come closer than the
above indicated minimum safe distance to the antenna i.e. 20 cm .
radio transmission, any person or persons can come closer than the
above indicated minimum safe distance to the antenna i.e. 20 cm .
To comply with current FCC RF Exposure limits, the antenna must be
installed at or exceeding the minimum safe distance shown above,
and in accordance with the requirements of the antenna manufacturer
or supplier.
installed at or exceeding the minimum safe distance shown above,
and in accordance with the requirements of the antenna manufacturer
or supplier.
Base Station Installation:
The antenna should be fixed-mounted on
an outdoor permanent structure.
RF Exposure compliance must be
addressed at the time of installation.
Antenna Substitution:
Do not substitute any antenna for the one
supplied or recommended by the manufacturer or radio dealer.
You
may be exposing person or persons to harmful radio frequency
radiation.
radiation.
You may contact your radio dealer or the manufacturer
for further instructions.
WARNING: Maintain a separation distance from the antenna to a
person(s) of at least
person(s) of at least
20 cm .
You, as the qualified end-user of this radio device must control
the exposure conditions of bystanders to ensure the minimum
separation distance (above) is maintained between the antenna and
nearby persons for satisfying RF Exposure compliance.
the exposure conditions of bystanders to ensure the minimum
separation distance (above) is maintained between the antenna and
nearby persons for satisfying RF Exposure compliance.
The
operation of this transmitter must satisfy the requirements of
Occupational/Controlled Exposure Environment, for work-related use.
transmit only when person(s) are at least the minimum distance from
the properly installed, externally mounted antenna.
Occupational/Controlled Exposure Environment, for work-related use.
transmit only when person(s) are at least the minimum distance from
the properly installed, externally mounted antenna.