Lotek Wireless Inc SRX600 User Manual
S E T U P M O D E
1)Comm
Guide to the SRX 600 receiver Rev A #10112
Chapter 3 - - Page 28
3
CMDS parameters the modem needs, consult the modem’s user guide or Lotek
Wireless Inc. for details.
Wireless Inc. for details.
I
NITIALIZING
THE
CMDS
FOR
THE
MODEM
CMDS stands for Command String and is used to initialize the modem.
As soon as a modem is connected to the receiver and the receiver is Online, the
CMDS parameters are sent to the modem. If no modem is connected the following
message is provided, “No Modem, please select it via Setup/Comm”.
CMDS parameters are sent to the modem. If no modem is connected the following
message is provided, “No Modem, please select it via Setup/Comm”.
If the modem’s CMDS parameters are edited via the SRX Host while the modem
is connected then the modem cannot function properly. There are two ways to
correct for this: initialize the modem or unplug the modem and then plug it back
into the receiver. In the case of the latter, as soon as the modem is again connected
to the receiver, the receiver sends the new CMDS to the modem (like a refresh).
is connected then the modem cannot function properly. There are two ways to
correct for this: initialize the modem or unplug the modem and then plug it back
into the receiver. In the case of the latter, as soon as the modem is again connected
to the receiver, the receiver sends the new CMDS to the modem (like a refresh).
Initialize the modem via Setup > 1)Comm > 1)Configure > 1)Serial I > 5)Modem
> 3)Initialize
> 3)Initialize
.
If a strictly RF modem is being used then Serial II can be used.
S
E T T I N G
D
E F A U L T
F
A C T O R Y
S
E T T I N G S
View the default factory settings via Setup > 1)Comm > 2)Factory Settings.
The factory default settings are available for Baud Rate, Parity, Data Bits and Stop
Bits. The default settings are shown in brackets in the display when this menu
item is selected.
Bits. The default settings are shown in brackets in the display when this menu
item is selected.
Factory default settings can be set for either Serial I or Serial II (or both) via Setup
> 1)Comm > 2)Factory Settings
> 1)Comm > 2)Factory Settings
> 1)Serial I or 2)Serial II.