Lotek Wireless Inc SRX600 User Manual
. . . . .
M A N U A L M O D E
2)Search
Guide to the SRX 600 receiver Rev A #10112
Chapter
4 - - Page 35
P
A U S I N G
A
S
C A N
Accessed via Manual > 2)Search > 1)Start > 0)Pause Scan. This function
suspends the scan cycle on the frequency and antenna that was being scanned
before pause was selected. This also means that the receiver does not change the
frequency or antenna it was scanning when pause was selected, but it does
continue logging data for that frequency and antenna.
suspends the scan cycle on the frequency and antenna that was being scanned
before pause was selected. This also means that the receiver does not change the
frequency or antenna it was scanning when pause was selected, but it does
continue logging data for that frequency and antenna.
R
E S U M I N G
A
S
C A N
Upon resuming a scan (Manual > 2)Search > 1)Start > 0)Resume Scan), the
receiver uses the last settings applied during the pause, thereby replacing the
previous values in the active configuration.
receiver uses the last settings applied during the pause, thereby replacing the
previous values in the active configuration.
S
E T T I N G
T H E
T
Y P E
O F
T
R A N S M I T T E R
T O
S
C A N
Via Search go to Manual > 2)Search > 1)Start > 2) Show Beep/ID/Sensor.
The type selected depends on the type that was selected before using this feature.
For example, if the scan was showing Sensor (SEN) type transmitters then
pressing 2)Show Beep/ID/Sensor once causes the type to change to Beep.
Pressing 2)Show Beep/ID/Sensor again switches the type to ID and so on.
For example, if the scan was showing Sensor (SEN) type transmitters then
pressing 2)Show Beep/ID/Sensor once causes the type to change to Beep.
Pressing 2)Show Beep/ID/Sensor again switches the type to ID and so on.
There is no indication given that the type of transmitter to scan has been changed.
Press the Left Arrow once to go back to the first page to see that the type has been
changed.
Press the Left Arrow once to go back to the first page to see that the type has been
changed.
S
E T
D
E L T A
F O R
F
R E Q U E N C Y
Set Delta is not used during a Search. Refer to section below, Defining a frequency
step, for details on how to define the gain increment during a Search.
step, for details on how to define the gain increment during a Search.
Set this increment via Manual > 2)Search > 1)Start > 3)Set Delta > 1)Freq.