Lotek Wireless Inc SRX600 User Manual
. . . . .
C O D E L O G M O D E
1)Config## > 3)Freq/Ch
Guide to the SRX 600 receiver Rev A #10112
Chapter
5 - - Page 57
removed from the scan cycle. By default all frequencies entered are considered
enabled.
enabled.
The receiver only scans frequencies that are enabled.
All frequencies can be enabled via Codelog > 1)Config## > 3)Freq/CH >
2)View/Modify > 2)EN
2)View/Modify > 2)EN
. Press the END/ESC key to go back to the Freq/Ch page.
The display shows two values in brackets after the page title (e.g. AllFreq/Ch(2,
4)). These numbers in brackets correspond to four of the menu items available:
2)EN, 3)Dis, 4)ID and 5)Sen. The first number in the brackets after the title is used
to show whether the frequencies in the frequency table are enabled (2) or disabled
(3). The second number is used to show if the transmitter type in use is ID only (4)
or ID with Sensor (5). After a key (2, 3, 4 or 5) is pressed the number in the
brackets changes accordingly.
4)). These numbers in brackets correspond to four of the menu items available:
2)EN, 3)Dis, 4)ID and 5)Sen. The first number in the brackets after the title is used
to show whether the frequencies in the frequency table are enabled (2) or disabled
(3). The second number is used to show if the transmitter type in use is ID only (4)
or ID with Sensor (5). After a key (2, 3, 4 or 5) is pressed the number in the
brackets changes accordingly.
A
S S I G N I N G
A
T
R A N S M I T T E R
T
Y P E
T O
A L L
F
R E Q
/ C
H
The receiver defaults to the ID only type for new frequency+channel assignments;
others must be specifically assigned.
others must be specifically assigned.
Assign a transmitter type via Codelog > 1)Config## > 3)Freq/CH >
2)View/Modify > 3)ID/Sen
2)View/Modify > 3)ID/Sen
.
The display shows two values in brackets after the page title (e.g. AllFreq/Ch(2,
4)). These numbers in brackets correspond to four of the menu items available:
2)EN, 3)Dis, 4)ID and 5)Sen. The first number in the brackets after the title is used
to show whether the frequencies in the frequency table are enabled (2) or disabled
(3). The second number is used to show if the transmitter type in use is ID only (4)
or ID with Sensor (5). After a key (2, 3, 4 or 5) is pressed the number in the
brackets changes accordingly.
4)). These numbers in brackets correspond to four of the menu items available:
2)EN, 3)Dis, 4)ID and 5)Sen. The first number in the brackets after the title is used
to show whether the frequencies in the frequency table are enabled (2) or disabled
(3). The second number is used to show if the transmitter type in use is ID only (4)
or ID with Sensor (5). After a key (2, 3, 4 or 5) is pressed the number in the
brackets changes accordingly.