Biolase Inc. EPIC-1 User Manual
EPIC™10 User Manual
pg. 25
5400525 Rev B
4.12 PROCEDURES BUTTON
The EPIC 10 has the ability to store up to 20 pre-set procedures; EPIC 10 is factory-installed
with 14 pre-programmed procedural presets and 6 empty slots for custom pre-sets. All of them
can be customized to your preference.
with 14 pre-programmed procedural presets and 6 empty slots for custom pre-sets. All of them
can be customized to your preference.
In order to customize the parameters for a particular clinical procedure:
1. Select PROCEDURES mode and scroll to the pre-set you wish to overwrite.
2. Adjust the operating parameters of the laser (e.g., power, pulse duration, interval, etc.).
3. Press and hold the name of the selected procedure (Figure 4.16) for approximately two (2)
seconds. Parameters for that procedure will be changed and saved (the laser console will
beep when the adjusted settings are saved).
beep when the adjusted settings are saved).
Figure 4.16
4.13 TURN THE LASER CONSOLE OFF
• Wind the fiber cable onto the fiber spool counterclockwise around the base of the console.
• Place the handpiece onto the handpiece holder.
• Place the handpiece onto the handpiece holder.
CAUTION:
Verify that the fiber optic tubing assembly is not twisted once the
handpiece is returned to the holder. The fiber may break if it is twisted.
handpiece is returned to the holder. The fiber may break if it is twisted.
• Press the CONTROL button on the front of the console for more than 2 seconds to turn
the display off.
• Press the Power Switch at the rear of the laser console to the OFF (O) position if the laser
system will not be used for a long period of time.