Thomson 2-1018A User Manual

Signal

Meaning

A long warbling tone (with ringer on)

Signals an incoming call

Three short beeps

Page signal

One short beep (every 7 seconds)

Low battery warning

No dial tone

• Check or repeat installation steps:

Make sure the base power cord is connected to a working
electrical outlet.

Make sure the telephone line cord is connected to the base and the
wall jack.

• Connect another phone to the same jack. If it doesn’t work, the problem

might be your wiring or local service.

• The handset may be out of range of the base. Move closer to the base

• Make sure the battery is properly charged (for 16 hours).

• Make sure the battery pack (in the handset) is properly installed.

• The handset should beep when you press the TALK/END/CALLBACK

button, and the charge indicator on the base should be lit when the
handset rests in the cradle. If not, the battery may need to be charged.

• Place handset in charge cradle for at least 20 seconds to reset the unit.

Handset does not ring

• Make sure the handset ringer software switch is set to on.

• The handset may be out of range of the base. Move closer to the base.