Badger Meter Inc BADGERAM User Manual

Program the ORION Transmitter
Badger Meter uses the Badger

-Radix

system to display and process screens.

Please reference the document “Instructions
for Installing ORION Gas Meters Using the
Radix Programming Tool”.

The meter is now installed. On the Badger-
Radix you’ll see the next meter number and
the process starts again.

Step 5: Care must be taken when placing a
transmitter/index unit on the meter.

Before placing the transmitter/index on the
gas meter put four (4) supplied plugs into the
rear of the transmitter.

Step 7: There is some adjustment in the
position of the index plate. Make sure the
index is positioned so the shaft turns freely
about ½ turn.

Step 6: When mounting an ORION

transmitter to a gas meter, make sure the gas
meter drive gear engages the transmitter drive
pawl. These two drive pawls must mate
without causing any binding or potential for
disengagement.

Drive Gear
Drive Pawl

Step 8: There are three (3) different lengths
of mounting screws in the transmitter kit.

Install the shortest screw in the top left (#1)
of the ORION transmitter.

Install the second longest screw in the top
right (#2).

Install the two (2) longest screws in the
bottom (#3 and #4).