INNCOM International Inc. 201104TXR User Manual
4
Copyright 2014 INNCOM by Honeywell
Figure 4 Top Housing Removal
To gain access to headers and connectors located on the PCBA, remove the B578 from the DIN rail or NEMA box
enclosure. Using a flat screw driver, lift the top housing away from the snap tangs on the bottom housing.
enclosure. Using a flat screw driver, lift the top housing away from the snap tangs on the bottom housing.
Figure 5 Mounting Screw Locations
To screw mount the B578, open the B578 as described above and remove the PCBA, which is held in place by 4
tangs located at its perimeter. Once the PCBA is removed
tangs located at its perimeter. Once the PCBA is removed
locate the 4 countersink posts
mount the bottom housing to the intended fixture using a self-tapping screw
mount the PCBA back on to the bottom housing
make the necessary wire connections (see Headers and Connectors below)
connect power to the DC jack
plug in Ethernet connection
snap the top housing back onto the unit
The Edge Router design mounts externally on a wall or ceiling or even on furnishings, if need be.