Climax Technology Co Ltd ACGSF1 User Manual

The Glass Break Detector detects the high frequency sound emitted by glass breakage and transmits signal 
to notify the alarm system control panel when it is triggered.     

 

z 

-Press the button once to send a learn code. 

-The tamper switch is compressed against the back cover and protects the Detector from cover 
opening or removal from mounted location 

The Breakaway Area has 2 knockouts where plastic is thinner for screw mounting. When the Detector 
is forcibly removed from mounting location, the Break Away area will detach and allow tamper switch to 
be activated. 

z 

z 

The LED indicators are inside the front cover and only visible when activated. 

z 

Red LED: The Red LED activates when: 
¾ 

Tamper Switch is activated. 

¾ 

Learn/Test button is pressed. 

¾ 

Glass break detected under Test Mode, Low Battery or Tamper open condition 

(The Red LED does not light up when glass break is detected during normal operation) 

z 

Green LED 

The Green LED activates when glass break is detected under Test mode. 

z 

1  Insert the battery to power on the device.

2  Put the Control Panel into learning mode, refer to panel manual for detail.

3  Press the Learn/Test button once to transmit learn code to panel.

4  Refer to panel manual to complete learning process.

5  Refer to panel manual to complete the learning process. 

z 

The Glass Break Detector sensitivity can be adjusted using the two dip switches. Adjust the sensitivity 
to change detector range.   

 

Sensitivity 

Dip Switch 1 

Dip Switch 2 

Detection Range