Climax Technology Co Ltd PB7 User Manual

                                                                       

The Fixed Panic Button is used to activate the panic alarm. 

1. Pressing the Button for 3 seconds will trigger the panic alarm regardless of 

whether the system is armed. 

2. The panic alarm is cancelled, if this button is pressed for more than 8 seconds. 

 

1. When the Button is pressed, the TX LED will flash one time, indicating a successfully signal sent from the Panic Button to the 

Control Panel. 

2. When the Button is pressed for more than 8 seconds, the TX LED will flash one time again to indicate the transmission of the 

Cancel Code. 

 

z 

For PB-7,-8,-A8, the Panic Button’s power source is one CR2032 3V 240mAh Lithium battery with a life expectancy of over 6 
years. 

In Low Battery condition, the Panic Button can operate for up to 4 months assuming 2 activations on average per day.   

The Panic Button will transmit any detected low battery status along with any regular status signal transmission to the Control 
Panel for display accordingly.   

Detection of Low Battery： 

1. 

If the Panic Button is in Low Battery condition and the Button is not pressed, the Panic Button will transmit the L.B. signal 
once every 18~22 hours. The panel will display the Panic Button L.B. status after the forth receipt of the low battery 
condition. 

2.   When the Panic Button is in Low Battery condition, the Panel will transmit the Panic Button L.B. status after the forth 

Button press. 

¾ 

The minimal interval between Button presses is one minute. If the Button is pressed e.g. three times within one 
minute, the panel will only recognize one press for the time period. 

¾ 

When changing battery, after removing the old battery, press the button twice to fully discharge before inserting 
new battery. 

 

z 

z 

Remove the screw and separate the cover from the base. 

z 

Insert the battery by the marked polarities. 

z 

Replace the top over the base and lightly tighten the screw. 

z 

Put Control Panel into (Device +/-) menu and select (Add Device) menu. 

z 

Press the button on the Panic Button. 

z 

Refer to your Control Panel’s operation manual, under the (Device +/-“) section to complete the learn-in process. 

 

z 

z 

Place the Control Panel in the walk test mode. 

z 

Press the Button once. 

z 

The Panel will display the RSSi (Radio Strength Signal) strength and sound a 2-tone beep. 

 

z 

z 

After the Panic Button is learned successfully, press Button for (3) seconds.    (The LED light will flash once indicating the 

Learning-in was successfully). 

z 

The Control Panel will immediately activate accordingly. Pressing the Button and holding for 8 seconds or more will send 

a Cancel Code to the Control Panel immediately deactivate the alarm 

1

2