Climax Technology Co Ltd WSLD User Manual
WS-LD.DOC 2006.01.26
1
1
2
W
W
S
S
-
-
L
L
D
D
W
W
a
a
t
t
e
e
r
r
S
S
e
e
n
n
s
s
o
o
r
r
Water Sensor is specially designed to detect if the water level is above a certain level that may damage your
protected goods. It is a device that helps to manage your protected place and goods by keeping it nice and
dry.
protected goods. It is a device that helps to manage your protected place and goods by keeping it nice and
dry.
I
I
d
d
e
e
n
n
t
t
i
i
f
f
y
y
i
i
n
n
g
g
t
t
h
h
e
e
p
p
a
a
r
r
t
t
s
s
:
:
Antenna
Learn / Test button
This button is used for testing the radio performance
and for learning purpose.
and for learning purpose.
Probe
Battery lid
This Probe is used for detecting the increasing water
level.
level.
Buzzer
Extension black wire with Probe
B
B
a
a
t
t
t
t
e
e
r
r
y
y
:
:
The WS-LD uses one 9V alkaline battery as its power source. The battery is good for at least 3 years
before it needs changing.
before it needs changing.
Low battery detection operates at a threshold of 3.3V
±10 % where the WS-LD has enough reserve
power to typically operate for 3 months before complete exhaustion. The WS-LD low battery signal will
be enunciated by one beep for every 45 secs.
be enunciated by one beep for every 45 secs.
<
<
N
N
O
O
T
T
E
E
>
>
WS-LD will perform one beep when the power is on.
WS-LD will only send low battery signal every 24 hrs after continuous 10 hrs of low battery
detection.
detection.
WS-LD will only detect the low battery when an alarm has been activated. The low battery
signal will be sent to the Control Panel along with the alarm signal transmission for the
Control Panel to display the status accordingly.
signal will be sent to the Control Panel along with the alarm signal transmission for the
Control Panel to display the status accordingly.
G
G
E
E
T
T
T
T
I
I
N
N
G
G
S
S
T
T
A
A
R
R
T
T
E
E
D
D
:
:
I
I
.
.
F
F
o
o
r
r
C
C
T
T
C
C
-
-
1
1
0
0
0
0
2
2
:
:
Remove the screw to separate the top cover from the base.
Insert the battery with negative of the battery on the spring side.
Place the top case over the base.
Put the Control Panel into “Device +/-“ menu and ten select “Add Device” menu.
Press any buttons on the WS-LD
Refer to the operation manual of your control panel under the section of “Device +/-“ to
complete the learn-in process.
complete the learn-in process.
3
4
5
6