HeathCo LLC 60WRC30TX User Manual

© 2002 DESA International

598-1116-00

• Products are UL/cUL and/or FCC/IC tested

and approved.

• Operational range of up to 100 feet.

This manual applies to the following products:
• 6-Button Remote Control
• Indoor Plug-In Receiver
• PAR Light Receiver
• Indoor/Outdoor Screw-In Light Receiver
• Remote Motion Sensor

This manual includes operating instructions for a variety of remote controlled products. All products
work on the same principle and use the same channel setting information. Please read all
instructional information and note any specific information pertaining to your particular product.

Note:

  One remote control is able to

independently operate two receiver units
set on the same channel. If more than
two receiver units, operating indepen-
dently, are desired, additional remote
controls will need to be purchased.

1. Install alkaline 12-Volt remote battery (A23

type). Remove cover from back of transmit-
ter. Using outline of battery chamber as a
guide, align battery with chamber and insert
battery. Slide cover onto transmitter.

ON

1 2 3 4

Battery

Chamber

(Type A23)

Battery

Cover

2. Remote Control Functions. The three but-

tons on the left side of the remote will oper-
ate one or more receiver units with matching
addresses. The three buttons on the right
side of the remote will operate a second set
of one or more receiver units.

• Channel 1/2 ON: Turns on any receiver unit set

to the same channel as this remote control.

• Channel 1/2 OFF: Turns off any receiver unit

set to the same channel as this remote control.

• Channel 1/2 DIM: Activates the DIM feature

for any receiver unit set to the same channel
as this remote control.

Note:

  To independently operate a second re-

ceiver unit using a single remote control, make
sure the 4th dip switch on each receiver is set to
different settings.
• Channel 1 - Slide dip switch 4 to the ON

position on each receiver to be operated by
these buttons.

• Channel 2 - Slide dip switch 4 to the OFF

position on each receiver to be operated by
these buttons.

Channel 1 DIM

Channel 1 ON

Channel 1 OFF

Channel 2 DIM

Channel 2 ON

Channel 2 OFF

Flat-Head

Screwdriver

Optional

Visor Clip

The remote control includes an optional car visor
clip for added convenience that may be installed.
1. To attach car visor clip to remote control (if

desired) push it into slot on rear of remote
unit until it snaps into place.

2. To remove car visor clip, insert a small, flat-

head screwdriver into slot on back of remote.
Gently push down on portion of visor clip
inside slot with screwdriver while pulling clip
out of remote from top.