Data Critical Corporation 00DT-7000 User Manual
USE AND MAINTENANCE
DT-7000 Operator’s Manual, Revision A
13
All information contained herein is subject to the rights and restrictions on the title page.
Attendant Present / Procedure Alarm Silence (PAS) Unlock Button
The Attendant Present push button has three functions. Each function is initiated
based on how long the button is pressed.
based on how long the button is pressed.
1.
Exiting the Standby Mode
DT-7001 - If the transceiver is powered by battery only, then pressing the Attendant
Present button will take the transceiver out of Standby Mode and all LEDs will illumi-
nate for a few seconds.
DT-7000 - If the transceiver is powered by an external power source, then pressing the
Attendant Present button will take the transceiver out of Standby Mode.
Present button will take the transceiver out of Standby Mode and all LEDs will illumi-
nate for a few seconds.
DT-7000 - If the transceiver is powered by an external power source, then pressing the
Attendant Present button will take the transceiver out of Standby Mode.
Note:
The LEDs are constantly illuminated when powered by an external source.
2.
Initiating an Attendant Present Alarm
Once the transceiver is out of the Standby Mode, pressing the Attendant Present but-
ton will activate the Attendant Present function and initiate an Attendant Present
Alarm at the Central Station.
ton will activate the Attendant Present function and initiate an Attendant Present
Alarm at the Central Station.
3.
Unlocking the PAS button
The PAS button must be disabled prior to initiating the Procedure Alarm Silence
alarm. In the “locked” position, the PAS button is disabled.
alarm. In the “locked” position, the PAS button is disabled.
To “unlock” the PAS key, press, and hold (for about two seconds), the Attendant
Present button until the Procedure Alarm Silence Status Indicator LED begins flash-
ing. Once the LED indicator starts flashing, the PAS button is in the “unlocked mode”
and functional.
Present button until the Procedure Alarm Silence Status Indicator LED begins flash-
ing. Once the LED indicator starts flashing, the PAS button is in the “unlocked mode”
and functional.
Note:
The PAS button must be pressed while the LED is still flashing. If it is
pressed after the LED has stopped flashing, then the PAS button will auto-
matically be “re-locked”.
pressed after the LED has stopped flashing, then the PAS button will auto-
matically be “re-locked”.