Data Critical Corporation 00DT-7000 User Manual
USE AND MAINTENANCE
18
DT-7000 Operator’s Manual, Revision A
All information contained herein is subject to the rights and restrictions on the title page.
Connecting to the Bedside Monitor
See Figure 1 on page 15 for an image of the DT-7000/DT-7001 controls and LED indi-
cators.
cators.
Note:
Before the transceiver is connected to the bedside monitor, the system
administrator must program it with the bedside device specific software
module.
administrator must program it with the bedside device specific software
module.
1.
Attach the transceiver to the bedside monitor by sliding the Device Hook over
the Mounting Disk until the transceiver snaps into place. The Mounting Disk
is provided with the transceiver and is attached to the bedside device through
adhesive or hardware tools.
the Mounting Disk until the transceiver snaps into place. The Mounting Disk
is provided with the transceiver and is attached to the bedside device through
adhesive or hardware tools.
2.
Connect the AC power adapter into the power port located on the bottom of
the transmitter.
the transmitter.
3.
Plug the AC power adapter into the wall electrical outlet. If the AC power
adapter is not used, the transmitter will operate either from its internal battery
(DT-7001 models) or from connection to the bedside device.
adapter is not used, the transmitter will operate either from its internal battery
(DT-7001 models) or from connection to the bedside device.
4.
Attach the host end of the I/O cable to I/O port 1 (Ports 2, 3 and 4 will be
functional in future releases).
functional in future releases).
5.
Attach the other end of the I/O cable to the bedside monitor.