Tyco Safety Products/Sensormatic AMS1140 User Manual
ULTRA•POST DETECTORS WITH SWITCHED MODE TRANSMITTER
8000-2595-07, REV. E
SETUP AND SERVICE GUIDE
6 of 15
Installing the hole plugs and conduit
clamps
clamps
WARNING!
DO NOT run the power
cable and the Interconnect cable in the
same conduit or raceway.
same conduit or raceway.
The hole plug and conduit clamps are installed in
the side of the pedestal base.
the side of the pedestal base.
Installing the voltage selection jumper
You must set the voltage selection jumper (J1) on
the lower right side of the main circuit board to the
proper setting. Refer to Figure 1. The default
setting is for 240Vac.
the lower right side of the main circuit board to the
proper setting. Refer to Figure 1. The default
setting is for 240Vac.
WARNING—RISK OF ELECTRIC
SHOCK!
SHOCK!
Disconnect AC power when
servicing.
•
For 120Vac operation, install the jumper
on J1. The jumper is in the pedestal
installation kit.
on J1. The jumper is in the pedestal
installation kit.
•
For 240Vac operation, remove the jumper
from J1 if it is installed.
from J1 if it is installed.
CAUTION: If you install the jumper for
120Vac and connect the pedestal to a
240Vac supply, the system will be
damaged.
120Vac and connect the pedestal to a
240Vac supply, the system will be
damaged.
If you set a pedestal to 240Vac and connect it to
120Vac power, the system will not operate
properly. Also, the system will generate a low
current error condition message (error number 21)
that can be read with the service configurator
software.
120Vac power, the system will not operate
properly. Also, the system will generate a low
current error condition message (error number 21)
that can be read with the service configurator
software.
Replacing the Alarm Board and
Lens
Lens
The alarm lens installation kit (0352-0444-02)
contains two alarm lens (one for each pedestal),
the alarm board, and six screws. You use four of
the screws for the two alarm lens. The other two
screws are for the grounding plate in the base;
they are not needed.
contains two alarm lens (one for each pedestal),
the alarm board, and six screws. You use four of
the screws for the two alarm lens. The other two
screws are for the grounding plate in the base;
they are not needed.
WARNING—RISK OF ELECTRIC
SHOCK!
SHOCK!
Disconnect AC power when
servicing.
1. Remove the two screws on the top of the alarm
lens.
2. Lift the alarm lens.
3. Disconnect the alarm cable from the alarm
board.
CAUTION: The alarm board is fragile;
use caution when handling it.
use caution when handling it.
4. Connect the alarm board to the alarm cable
connector on the top of the primary pedestal
5. Remove the adhesive backing and stick the
alarm board to the center of the top of the
pedestal. Make sure you align the arrow on the
alarm board with the groove on the top of the
pedestal. Note: the pedestal top has a slight
depression for the alarm board but the alarm
board overlaps it when the arrow on the alarm
board is properly aligned with the groove.
pedestal. Make sure you align the arrow on the
alarm board with the groove on the top of the
pedestal. Note: the pedestal top has a slight
depression for the alarm board but the alarm
board overlaps it when the arrow on the alarm
board is properly aligned with the groove.
Conduit clamp
Hole plug