Seiko Instruments AB000002 User Manual

4 PAPER SETTING

This printer can feed cut sheets and paper roll. The printer function setting for cut

sheets is different from that for paper roll. See Section 6 Function Setting for details.

(1) Turn the printer on.

(2) If the printer has been stored without

thermal paper, open and close the

paper cover (see Section 2 EACH

PART OF PRINTER) before setting the

cut sheet.

(3) Insert a cut sheet into the paper slot in

the printer until it stops with its printable

surface facing down.

(4) The printer detects the paper and loads

it automatically.

(5) To discharge the paper from the printer, hold down the FEED switch.

CAUTION

Take care not to get your fingers caught in the printer when loading

paper.

NOTE

Insert the paper into the paper slot straight. If it is askew, a paper feed

error occurs.

DO NOT block the paper outlet or hold the paper that is being loaded.

Otherwise, it may cause a paper jam.

HINT

• Marks for paper position detection are printed on the back of the

specified paper. When the printer detects the mark, it enters print-ready

mode.

• If the printer does not detect a mark, the ERROR lamp blinks. Press the

FEED switch once or turn the printer off and on again to clear the error.

Place a cut sheet with the paper
position detection mark facing up.