Park Air Systems Limited B6350 User Manual
Chapter 4.
AM-Voice Operational Settings
This chapter details how the T6T transmitter is set up for AM voice operation from the front panel.
It also details how to set the transmitter in and out of standby mode.
The transmitter can also be set up through a MARC system, or by using the VFP. Both of
these methods are outside the scope of this handbook; users should refer to the MARC
User Guide and the T6T Maintenance Handbook.
INTRODUCTION
Selecting most of the transmitter's operational settings is carried out using the front panel Scroll/Select
switch and the LCD (see the illustration below). Table 2-2 on page 19 shows a list of the operational
settings. No attempt to set up the transmitter should be made until the transmitter has been installed as
per the Installation Procedures given in section 1 of this user guide.
switch and the LCD (see the illustration below). Table 2-2 on page 19 shows a list of the operational
settings. No attempt to set up the transmitter should be made until the transmitter has been installed as
per the Installation Procedures given in section 1 of this user guide.
Normal Operation
During normal operation, the LCD displays the Main screen. This screen shows the operating frequency,
the channel number (if the channel store facility is used), the carrier offset (if used), and displays a
graphical representation of output power when the transmitter is keyed. If the transmitter has been set to
Standby mode, which is shown by the front panel STANDBY indicator being lit, the LCD is blanked.
the channel number (if the channel store facility is used), the carrier offset (if used), and displays a
graphical representation of output power when the transmitter is keyed. If the transmitter has been set to
Standby mode, which is shown by the front panel STANDBY indicator being lit, the LCD is blanked.
Using the Scroll/Select Switch
The SCROLL/SELECT switch (referred to throughout this chapter as the ‘Switch’) is used to leave the
Main screen and display the Options menu. Further use of the Switch displays various selection menus
and allows the required parameters to be set. The switch has three actions: it can be turned clockwise,
anti-clockwise, or momentarily pushed in.
Main screen and display the Options menu. Further use of the Switch displays various selection menus
and allows the required parameters to be set. The switch has three actions: it can be turned clockwise,
anti-clockwise, or momentarily pushed in.
T6T AM-Voice Operation
Section 2
Page 17
F r e q
1 2 3 . 0 0 0 M H z
C h a n
1
O f f s e t
+ 5 . 0 k H z
P w r
l l l l l l l l l l l