Park Air Systems Limited B6350 User Manual
GENERAL TRANSMITTER SETTINGS
During this procedure the following parameters are set:
q
Setting the LCD backlight
q
Setting inhibit to on or off
q
Setting the input line level
q
Setting the output power
q
Setting the MARC baud rate
q
Setting the PTT input signal polarity
q
Setting the PTT output signal polarity
q
Setting the inhibit input signal polarity
q
Setting the BIT initiate signal polarity
q
Setting the Ready output signal polarity
q
Setting the antenna change-over signal
polarity
polarity
1.
From the Main screen, press the switch to
display the Options menu. Turn the switch
until Configure is highlighted. Press the
switch.
display the Options menu. Turn the switch
until Configure is highlighted. Press the
switch.
2.
Ensure the Configure menu is displayed.
Turn the switch until Settings is highlighted,
then press the switch to display the Function
menu.
Turn the switch until Settings is highlighted,
then press the switch to display the Function
menu.
3.
Ensure the Function menu is displayed. Turn
the switch until Display is highlighted.
the switch until Display is highlighted.
T6T AM-Voice Operation
Section 2
Page 29
F r e q u e n c y
C h a n n e l
C o n f
i g u r e
B I T
E x i
t
Options Menu
S e t t
i n g s
S / W
V e r s i o n s
S t a n d b y
B a c k
E x i
t
Configure Menu
M o d e
R e f e r e n c e
F r e q
D i s p l a y
> >
Function Menu