Digital Monitoring Products Inc PC0103 User Manual
Digital Monitoring Products
1125 PIR Installation Guide
2
1125 PIR Installation Guide
Digital Monitoring Products
3
Selecting the Proper Location (LED Survey Operation)
Note: Refer to Figure 2 to remove the 1139 housing base and Figure 3 for the 1139 PCB LED and tamper switch
locations.
The 1139 Bill Trap provides a survey capability to allow one person to confirm transmitter communication with
The 1139 Bill Trap provides a survey capability to allow one person to confirm transmitter communication with
the receiver while the cover is removed. The 1139 Bill Trap PCB Red Survey LED turns on whenever data is sent
to the receiver then immediately turns off when the
receiver acknowledgement is received. Pressing the
tamper switch is a convenient way to send data to the
receiver to confirm operation. When the tamper switch
is pressed or released, the LED blinks once to indicate
proper operation. When the transmitter does not receive
an acknowledgement from the receiver the LED remains
on for about 8 seconds or flashes multiple times in
quick succession to let you know communication is not
established. Relocate the transmitter or receiver until
the LED immediately turns off indicating the transmitter
and receiver are communicating properly. Proper
communication between the transmitter and receiver
is verified when for each press or release of the tamper
switch, the LED blinks immediately on and immediately
off. Repeat this test to confirm five separate consecutive
LED blinks. Any indication otherwise means proper
communication has not been established.
Installing the Bill Trap
Slide a bill into the Bill Trap on the 1139 as shown in Figure 1. The 1139 Bill Trap unit easily slides into a bill slot of a
cash drawer. Place additional bills above the trapped bill for standard cash drawer operation.
Installing or Replacing the Battery
Observe polarity when installing the battery. Use only 3.0V lithium
batteries, DMP Model CR2450, or the equivalent battery from a local retail
outlet.
Note: When setting up a wireless system, it is recommended to program
Note: When setting up a wireless system, it is recommended to program
zones and connect the receiver before installing batteries in the
transmitters.
To install or replace batteries or access the tamper switch and view the LED
To install or replace batteries or access the tamper switch and view the LED
flash:
1. Use a Phillips screwdriver to remove the three screws holding the base
and housing together. See Figure 2.
2. Gently lift the PCB out of the housing.
3. If installed, push and slide each old battery out of the holder in the
3. If installed, push and slide each old battery out of the holder in the
direction of the arrow to remove it. See Figure 3.
4. Verify the positive side of the new battery is up.
5. Slide each new 3.0V lithium battery into its holder and push into
5. Slide each new 3.0V lithium battery into its holder and push into
place.
Lever Alarm
Switch
Universal
Antenna
CR2450 Coin Cell Batteries
with Positive Side Up
Tamper
Switch
Push the Battery
Edge to Slide
Battery Out
Red LED
Figure 3: Bill Trap Battery Locations
Bill Trap Housing
Base Mounting
Screw Locations
Figure 2: Bill Trap Base and Mounting Screw Locations