Digital Monitoring Products Inc PC0132 User Manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions:

(1) This device may not cause harmful interference, and
(2)  This device must accept any interference received, including interference that 

may cause undesired operation.

Changes or modifications made by the user and not expressly approved by the party 

responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined 

by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-  Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Industry Canada Licence-exempt RSS standard(s). Operation 

is subject to the following two conditions: (1) this device may not cause interference, 

and (2) this device must accept any interference, including interference that may 

cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux 

appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions 

suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de 

l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage 

est susceptible d’en compromettre le fonctionnement.