Digital Monitoring Products Inc PC0137 User Manual

The 738Z Z-Wave module is programmed from the panel programming menu after the Device Setup menu. Refer 

to the XT30/XT50 Series Programming Guide (LT-0981) or the XTL Programming Guide (LT-1108) for information on 

programming the 738Z into the panel.  

Two LEDs display receiver operation and activity.  Refer to the table below as required.

PTX Green LED (Far left LED) - Flashes to indicate data is being sent to the panel.
ZTX Green LED (Middle LED) - Flashes to indicate data is being sent to the Z-Wave controller.
ZRX Yellow LED (Far right LED) - Flashes to indicate data is being received from the Z-Wave controller.

•  Z-Wave Thermostat (DMP Model Z-TZEMT400BB3X) 

 

•  Z-Wave Light Control Module (DMP Model Z-45603)
•  Z-Wave Light Control Module with Dimmer Switch (DMP Model Z-45602)
•  Z-Wave Deadlock Door - Polished (DMP Model Z-99100-004)
•  Z-Wave Deadlock Door - Satin (DMP Model Z-99100-005)
•  Z-Wave Deadlock Door - Venetian (DMP Model Z-99100-006)

The 738Z module can be controlled from a cell phone using MyAccess™ Text Messaging commands.

Action

Text Command to send to panel

List loocks that are unlocked

STATUS LOCKS

Lock a specific lock (enter name of lock)

LOCK NAME

Unlock a specific lock (enter name of lock)

UNLOCK NAME

List lights that are on

STATUS LIGHTS

Turn on a specific light (enter name of light)

TURN ON NAME

Set a specific dimmer to level xx (enter name of light 

and dimmer level)

TURN ON NAME LEVEL

Turn off a specific light (enter name of light)

TURN OFF NAME

List status of all thermostats (inclluding system 

setting and temperature of room)

STATUS THERMOSTATS

Set the thermostat to Cool or Heat with this 

temperature (enter name of thermostat and 

temperature)

SET NAME COOL TEMP

SET NAME HEAT TEMP

Set the thermostat to Auto with heat and cool temps 

(enter name of thermostat, auto and high and low 

temperatures)

SET NAME AUTO HI LO

Set the thermostat to Auto with one temperature 

(enter name of thermostat, auto and temperature)

SET NAME AUTO TEMP

Set the thermostat fan to Auto or On (enter name of 

thermostat, fan and auto or on)

SET NAME FAN ON

SET NAME FAN AUTO

Set the thermostat to a specific temperature, but do 

not change the current AUTO/COOL/HEAT setting 

(enter name of thermostat and temperature)

SET NAME TEMP