Digital Monitoring Products Inc PC0152 User Manual

1127C is an 1100 Series Wireless Wall Mount Curtain PIR. The Detection area is a 50’ x 10’curtain using a fresnel lens. 

The PIR includes a case tamper and functionality to allow sensor configuration from the control panel. DMP Exclusive 

Features include Sensitivity Adjustment, Pulse Count, Walk Test, & Disarm Disable.

• Remote configuration from panel
• Excellent R.F.I. and noise immunity
• Adjustable sensitivity from panel programming
• Pulse count selection allows multiple triggers 

before an alarm is initiated

• Walk Test mode initiated from panel
• Disarm Disable operation to save battery life
• Installs up to 8’ wall height

• All DMP 1100 Series Wireless Receivers and panels

The 1127C Series PIR Motion Detector includes the 

following:

• One PIR detector with DMP wireless transmitter
• Two CR123 batteries
• Zone name and number label
• Serial number label

For your convenience, an additional pre‑printed serial number label is included. Prior to installing the device, record 

the serial number or place the pre‑printed serial number label on the panel programming sheet. This number is 

required during programming. As needed, use the zone name and number label to identify a specific transmitter.

The PIR transmitter provides a survey capability to allow one person to confirm transmitter communication with the 

receiver while the cover is removed. The PIR transmitter PCB Red Survey LED turns on whenever the processor turns 

on to send data to the receiver then immediately turns off when the receiver acknowledgement is received and the 

processor shuts off. While in Walk Test mode, waving your hand in front of the PIR is a convenient way to send data 

to the receiver to confirm operation. The PIR 

circuit board LED lights to indicate motion 

and the Survey LED briefly lights to confirm 

communication.

When the transmitter does not receive an 

acknowledgement from the receiver, the 

transmitter Survey LED remains on for about 

8 seconds to let you know communication is 

not established. Relocate the transmitter or 

receiver until the Survey LED immediately 

turns off indicating the transmitter and 

receiver are communicating properly. If the 

transmitter is not programmed into the panel, 

the Survey LED does not operate properly.

Cover Lock Screw