Digital Monitoring Products Inc PC0156 User Manual

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference 

to radio communications. However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the interference 

by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.

•  Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.
This device has been designed to operate with the integrated 1100 Series PCB antenna having a maximum 

gain of 1.8 dB. Antennas having a gain greater than 1.8 dB are strictly prohibited for use with this device. 

The required antenna impedance is 50 ohms.

If necessary, the installer should consult the dealer or an experienced radio/television technician 

for additional suggestions. The installer may find the following booklet, prepared by the Federal

Communications Commission, helpful:

“How to identify and Resolve Radio-TV Interference Problems.”

 

This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402

Stock No. 004-000-00345-4

This device complies with Industry Canada Licence-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de

licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de 

brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d’en compromettre le fonctionnement.

© 2015 Digital Monitoring Products, Inc.

Information furnished by DMP is believed to be accurate and reliable.

This information is subject to change without notice.

Throughout this guide you will see caution notes containing information you need to know when installing

the EM20. These cautions are indicated with a yield sign. Whenever you see a caution note, make sure you

completely read and understand its information. Failing to follow the caution note can cause damage to the 

equipment or improper operation of one or more components in the system.