Digital Monitoring Products Inc PC0159 User Manual

15

The Communication section allows you to configure the communication settings for the

CellComSL Series Cellular Alarm Communicator. After choosing the Communication Type,

continue through the list of options.

Enter the account num ber sent to the receiver.

CELL - The range of account numbers is 1 to 65535. For account numbers of four digits

or less, you do not have to enter leading zeros. The communicator automatically right 

justifies the account number.

Enter the number of seconds (15 to 45 seconds) the communicator waits before sending 

burglary alarm reports to the receiver. Enter 0 (zero) to disable this function. The

default is 30.

If the area where the alarm occurred is disarmed during the Transmit Delay time, only

an Abort Report (S45) message is sent to the receiver. If the area where the alarm

occurred is disarmed after the alarm message is sent to the receiver but before the Bell 

Cutoff time expires, even if the alarm was silenced, an Alarm Cancelled (S49) message is

sent. The Alarm Cancelled report cannot be disabled.

 The  communicator uses CELL communication to DMP Model SCS-1R or SCS-VR Receivers.

Press COMMAND to enter the Test Time. Enter the time of day the communicator sends 

the test report to the SCS-1R or SCS-VR Receivers. Use entries between 12:00 to 11:59

and then choose AM or PM.

Check-in reports are a method of supervising the panel for communication with the

receiver.
Enter the number of minutes between check-in reports. Select from 0 or 3-240 minutes.

Enter 0 (zero) to disable the check-in option. Default is 0.

Note: If Cell Check-in option is used, additional cell charges may apply.

Fail Time allows the SCS-1R or SCS-VR receiver to miss a defined number of check-ins

before logging that the panel is missing. For example, if 

CELL CHECKIN is 20 and FAIL 

TIME is 30, the SCS-1R receiver only indicates a Panel Not Responding after 30 minutes.

The 

FAIL TIME must be equal to or greater than the CELL CHECKIN minutes: If the 

CHECKIN is 20 minutes, the

FAIL TIME must be 20 or more. The maximum FAIL TIME is 

240 minutes. Select from 0 or 3-240 minutes. The default

FAIL TIME is 240 minutes.

Allows you to set the options for the first receiver the communicator attempts to 

contact when sending reports. The communicator supports communication to two 

receivers.

YES enables Abort, Alarm, Alarm Restoral, Alarm Bell Silenced, Ambush, Exit Error, and

System Recently Armed reports to be sent to this receiver. Default is YES

YES enables Supervisory, Trouble, Trouble Restoral, Force Armed, Late to Close, and

Fault reports to be sent to this receiver. Default is YES.

YES enables Opening/Closing, Door Access, Schedule and Code Changes, and Bypass

reports by user to be sent to this receiver. Default is YES.

Enter YES to enable the Recall Test report to be sent to this receiver.

Enter the first (primary) IP address where the communicator sends cell messages. The IP 

address must be unique and cannot be duplicated on the network. Enter all 12 digits and

leave out the periods. For example, enter IP address 192.168.0.250 as 192168000250.

The periods display automatically.

COMMUNICATION

ACCOUNT NO:

XMIT DELAY:   0

COMM TYPE:     CELL

TEST TIME
00:00  

AM PM

 

CELL CHECKIN:     0

FAIL TIME:           240

RECEIVER 1 PROG

ALARM  

NO YES

SPV/TRBL NO 

O/C USER 

NO  YES

TEST RPT 

NO  YES

FIRST IP ADDR 
000.000.000.000