Digital Monitoring Products Inc PC0159 User Manual

Page of 36
CellComSL
 
Series Communicator Install/Programming Guide 
Digital Monitoring Products
1
INTRODUCTION
CellComSL™ Series Cellular Alarm Communicator
Description
The CellComSL™ Series Alarm Communicator provides a fully supervised alarm communication path for any burglary
control panel. The CellComSL Series communicators can be connected to a control panel’s dialer output and used
to capture Contact ID messages. The CellComSLC has a built-in CDMA cellular module to send messages to DMP
Model SCS-1R or SCS-VR Central Station Receivers. The communicator also provides three burglary zones and two 
open-collector outputs for connection to burglary control panel outputs and zones. Intrusion detection devices, 
such as PIRs, door/window contacts or holdup buttons, can be wired to the three zones on the CellComSL. The
CellComSL Series Communicator Zone 4 provides a connection to the bell output of an existing burglary control
panel. The CellComSLCZ™ Alarm Communicator includes an onboard Z-Wave controller for home automation
applications. 
What is Included
The CellComSL Series Cellular Alarm Communicator includes the following:
•  PCB with Enclosure
•  3.7 VDC 800 mAh Lithium Ion Battery
•  Hardware Pack
System Components
1.1  Terminals (J9)
Power Connection Terminals
Power is provided from the 12 VDC auxiliary output of the burglary control panel.
OBSERVE POLARITY (See Figure 1)
1.   Using 18 - 22 AWG wire, connect the communicator terminal +12 to the positive terminal on the control 
panel auxiliary output.
2.   Connect the communicator terminal G (Ground) to the negative terminal on the control panel auxiliary
output.
Standby Battery
During a power outage, the CellComSL draws power from the burglary control panel’s backup
battery. The CellComSL must be included in the standby battery calculations for the burglary
control panel.
Zones 1-3
Terminals Z1 to Z3 and G (Ground) provide three zones to connect to individual outputs on the
burglary control panel or to intrusion devices (PIR, door, panic buttons or windows contacts). 
Figure 1: CellComSL Series Communicator
RESET
LOAD
B
AT
MODEL CellComSL
PROG
S N
+12
G
Z1
Z2
Z4-
Z4+
G
Z3
R
T
O2
O1
R
B
J8
J26
J9
S1
S2
S3
SYSTEM COMPONENTS
RESET
LOAD
B
AT
MODEL CellComSL
PROG
S N
+12
G
Z1
Z2
Z4-
Z4+
G
Z3
R
T
O2
O1
R
B
J8
J26
J9
S1
S2
S3
Figure 2: Zones 1 - 3