Digital Monitoring Products Inc PC0163 User Manual

14

This section allows you to enter the information needed to send and receive messages 

directly to and from the panel via MyAccess™ text messaging using CDMA cellular

communication. The Destination addresses allow up to 48 characters to be entered.

System Name is displayed with initial caps.

The transmitted messages are:

•  Zone Alarms by Zone Name
•  Zone Troubles by Zone Name
•  Zone Bypass by User
•  Arming (Closings) by User
•  Disarming (Openings) by User
•  AC Power Trouble and Restoral
•  System Low Battery
•  Cancel by User

Select YES to allow the panel to send messages to three programmed destinations.

Default is NO.

Enter a unique name for the communicator. The communicator name is used as the 

sender of the message. The text entered is displayed with initial caps. If this field is left

blank, the communicator account number is sent.

Enter the first cell phone number where messages will be sent. The message can be sent

to any cell phone as long as a valid cell phone number is entered.

Enter a user’s user number from this account. This option is used when sending commands

such as arming or disarming back to the CellComSL using MyAccess™ text messaging from

the same cell phone. The user number must have the authority to perform the commands. 

Entering 0 (zero) disables this option. Default is 0.

Enter the second destination cell phone number.

Enter the user’s User Number for arming/disarming authorization.

Enter the third destination cell phone number.

Enter the user’s User Number for arming/disarming authorization.

Select

YES to allow the panel to send Opening and Closing messages to a cell phone via

SMS protocol. Default is NO.

This number limits the monthly incoming and outgoing SMS messages allowed to be sent

or received by the communicator.

A panel event that causes messages to be sent to destination cell phone numbers is

counted towards the communicator’s monthly limit. For example, SMS messages sent

from a cell phone to the communicator including status requests and alarm messages 

received from the communicator all count toward the monthly limit. The limit is reset 

at midnight on the 14th of every month. Range is from 0 to 999. When 0 is entered,

there is no limit on the number of messages able to be sent or received by the panel. 

Default is 0.

MESSAGING SETUP 

DESTINATION 1

-

DESTINATION 2

-

 

DESTINATION 2 

USER NUMBER: 

0

DESTINATION 3 

-

SYSTEM NAME

-

ENABLE MESSAGING

YES

 

DESTINATION 1 

USER NUMBER: 0

O/C  SMS 

NO YES

 

DESTINATION 3 

USER NUMBER: 

0

MONTHLY  LIMIT:  

0