Digital Monitoring Products Inc PC0163 User Manual

28

 This feature allows the installer to test CellComSLCZ communication with Z-Wave

devices. A successful test indicates a response from a device. Press any top row Select

key to view the Z-Wave Device List.

Press COMMAND to advance through each Z-Wave device and press any top row Select

key to begin the test on the device displayed.

The name of the device displays above the device number. The current number of 

successful communications followed by the total number of attempts displays to the 

right of the device number. The test stops after 99 attempts.

Press COMMAND to view the final number of successful communications.

This displays DTMF digits dialed from the burglary control panel.

Press the COMMAND key until STOP displays. Press any Select key. The keypad returns to the Status List display.

When not in the Programming Menu, the function 984 + COMMAND can be entered at the keypad, and a remote

options menu appears. This menu contains the following options:

The communicator allows you to perform a test on each component of the cellular communication paths. While

the Status List displays, enter 984 and press the COMMAND key. Press the Select key under

 CELL to allow the 

communicator to perform a Communication Status Test. The keypad displays

CELL IS BUSY if the modem is being 

tested from another keypad.
Upon entry of a Cellular path when prompted, the test runs and the results display on the keypad in the order

they were tested: MODEM OPERATING, IDENTIFIED,TOWER DETECTED, REGISTERED, CONNECT SUCCESS, and CELL

COM GOOD. Press COMMAND to advance through the results. When the test is complete you are returned to the

Status List. See the Diagnostic Functions section for a description of the Cellular Status results.

The communicator provides a walk test feature that allows a single technician to test all the zones on the

system. Conduct the Walk Test within 30 minutes of resetting the communicator. The Walk Test automatically

ends if no zones are tripped for 20 minutes.

TEST IN PROGRESS displays at all keypads. When five minutes

remain, 

TEST END WARNING displays. If any areas are armed the Walk Test does not start and SYSTEM ARMED 

displays.

To conduct the Walk Test, reset the communicator by momentarily pressing the RESET

button. From the keypad, enter the code 8144. The keypad displays

WALK TEST. If 

the system is monitored , the system sends a System Test Begin report to the Central

Station. All programmed zones are included in the test.

Displays the number of zone trips during the Walk Test.

•  Each time a selected zone trips, the keypad buzzes.

END - Press the Select key directly below END to stop the Walk Test. When the Walk Test

ends or a 20 minute time-out expires, a final Sensor Reset occurs. The System Test End

message is sent to the receiver along with Verify and Fail messages for each zone under 

test. Faulted zones then display on the keypad.

When no zones have been tripped and five minutes remain on the 20 minute Walk Test

timer, the keypad displays TEST END WARNING and the keypad tones. If no additional

test zone trips occur, the test ends and a final Sensor Reset automatically occurs. The

System Test End message is sent to the receiver along with Verify and Fail messages for

each zone under WALK test. Faulted zones then display on the keypad.

Each zone that did not trip at least once during the Walk Test displays on the keypad

that initiated the test. Any Panic (PN) or Supervisory (SV) 24-hour zone that is faulted

at the end of the Walk Test displays a trouble condition for that zone regardless of the

message programmed for the open or short condition of the zone and a zone trouble is 

sent to the receiver. Press the COMMAND key to display the next failed zone.

TEST ZWAVE
DEVICE LIST:

HALLWAY LIGHT
HALLWAY LIGHT

LIGHT 02          0/0
HALLWAY LIGHT

99/99    SUCCESSFUL

WALK TEST

WALK TEST

TRIPS: XXX   

END

TEST END WARNING

SOUTH LOBBY

ZONE: 10 

  -FAIL