Rhine Electronics Co Ltd GTXE User Manual

INSTRUCTIONS FOR OPERATION 

SETING THE OPERATING CONTROLS 

 

 

 

 

 

 

 

 

  1.Loosen the screw to lift the back case of transmitter. 
  2.Choose the different function (3 Opr / 3 Ch) by inserting    
    the Mini Jumper into the left or the right of Pin Header. 
 

Proper disposal of battery is required. Refer to your local codes 
for disposal requirement.   

 

3Opr: Open/Stop/Close Operation   
(The Mini Jumper on the left side of Pin Header) 
 
The remote control can be programmed to operate one door 
using all 3 buttons: the up button will only open the door, the 
middle button will stop the door's movement, and the third button 
will only close it. 
 

  You may set up this feature as follows: 

1. Press and release the "learn" button (on the right side of 

the panel). 

2. When the green indicator light is illuminated, press and    
  hold any one of the three buttons on transmitter. 
3. After the green indicator light flashes three times, release   
  the button. 
4. This separately stores open/stop/close function for the    
  three buttons in memory. 

 

 

 

 

 

 

 

 

 

   

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 mini jumper   

3Ch: Channel Remote Control 
(The Mini Jumper on the right side of Pin Header)                      3 Ch  ←   → 3 Opr                    
 
Permit to control 3 separate openers. Each button can operate 
one particular door individually. 
 

  You may set up this feature as follows: 

1. Press and release the "learn" button (on the right side of   
  the panel). 

  2. When the green indicator light is illuminated, press and   
    hold the selected remote control push button. 
  3. After the green indicator light flashed three times, release   
    the button. 

5. This stores open/stop/close function for the selected   
  button for the first opener in memory. 
6. Repeat the same steps above on the second and third    
  openers. 

 
Erase All Remote Control Codes 
 
1. Press and hold the "learn" button (on the right side of 

the panel) until the green indicator light flashes (about 5 
seconds). 

2. All transmitter codes are now erased. 
  Then follow the steps above to re-program each remote control.