Williams Sound DLT300 User Manual

12

There are 4 basic steps to programming a Digi-wave system:  
1.  Set Mode: 2-way or 1-way
2.  Set Priority: Master 1, Master 2, and Guest
3.  Set Address
4.  Set Group Number
Most of the programming is done on the DLT(s); the receivers just need to be assigned the correct group number. The Master 1 

There are (3) 2-way Modes represented by these symbols on the LCD Display:
2-way:  
2-way - Listen only:  
2-way - Intercom:  

a. With the DLT turned on,  press and hold the 

 and 

  buttons until the icons on the display begin flashing.

b. Use either of the the 

  buttons to scroll through the different icon combinations (modes).

c. When you reach 2-way mode, the icon(s) will be flashing (alternately).   Go to step 2.

a. Push the 

  button to advance to the priority setting.

b. Use either of the the 

  buttons to scroll through the different priorities. Speaker priority is assigned as follows: 

1st priority — Master 1 ( M1 ) :  

  (Must have one per group)

2nd priority — Master 2 ( M2 ) :   

   (Optional)

3rd priority — Guest ( GST ) :    

  (All other units in the same group)

c. When you reach the priority you want, go to the next step.

a. Push the 

  button to advance to the address setting.  “ADD” will flash and the current address will be displayed.

b. Use either of the the 

  buttons to change the address. 

c. Each unit must have a different (unique) address assigned.

a. Push the 

  button to advance to the group setting.  “GROUP” will flash and the current group will be displayed.

b. Use either of the the 

  buttons to change the group. 

c. All units operating together should have the same group number..