NBS Payment Solutions Inc. 030874 User Manual

Page of 4
 
 
WLM-01 WLAN User Manual 
 
Agency Certifications: 
FCC ID:  COL-030874 
IC:  2279B-030874 
HVIN:  WLM-01 
 
AGENCY STATEMENTS
 
FCC Interference Statement: 
 
This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules and Industry Canada RSS 
standard(s). These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates uses 
and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not occur 
in a particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equipment 
off and on, the user is encouraged to try to correct the interference by one of the 
following measures: 
  Reorient or relocate the receiving antenna. 
  Increase the separation between the equipment and receiver. 
  Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.  
 Consult the dealer or an experienced radio/TV technician for help.  
 
INDUSTRY CANADA STATEMENTS: 
 
Under Industry Canada regulations, this radio transmitter may only 
operate using an antenna of a type and maximum (or lesser) gain approved for 
the transmitter by Industry Canada.  To reduce potential radio interference to 
other users, the antenna type and its gain should be chosen so that the 
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary 
for successful communication. 
This device has been designed to operate with the antenna(s) listed below 
Antennas not included in this list or having a gain greater than 4.4 dBi are 
strictly prohibited for use with this device. The required antenna impedance is 50 
ohms. List of all Antennas Acceptable for use with the WLM-01: 
1) AMCA72-2R470G-S1F from Abracon 
2) ANTX200P001B24003 from Yageo