AMX WAP250G User Manual
System Configuration
2-18
2
Time and Log
Simple Network Time Protocol (SNTP) allows the access point to set its internal
clock based on periodic updates from a time server (SNTP or NTP). Maintaining an
accurate time on the access point enables all system log messages to be stamped
with the correct time and date. If the clock is not set, the access point only records
the time from the factory default set at the last bootup.
clock based on periodic updates from a time server (SNTP or NTP). Maintaining an
accurate time on the access point enables all system log messages to be stamped
with the correct time and date. If the clock is not set, the access point only records
the time from the factory default set at the last bootup.
The access point acts as an SNTP client, which periodically sends time
synchronization requests to a specific time server. SNTP uses Coordinated
Universal Time (or UTC, formerly Greenwich Mean Time, or GMT) based on the
time at the Earth’s prime meridian, zero degrees longitude. To display the time
corresponding to your local time, you must also indicate the number of hours your
time zone is located before or after UTC/GMT.
synchronization requests to a specific time server. SNTP uses Coordinated
Universal Time (or UTC, formerly Greenwich Mean Time, or GMT) based on the
time at the Earth’s prime meridian, zero degrees longitude. To display the time
corresponding to your local time, you must also indicate the number of hours your
time zone is located before or after UTC/GMT.
Figure 2-16. SNTP Settings
The displayed items on this page can be described as follows:
• SNTP Server Setting — Configures the access point to operate as an SNTP client.
When enabled, the time server IP address must be specified.
• Primary Server: The IP address of an SNTP or NTP time server that the access
point attempts to poll for a time update.
• Time Zone — Sets the number of hours your local time zone is located before or
after UTC/GMT. (Default: GMT+00)