Shure FP3L User Manual
FP5
3
1
2
3
PGX1
4
5
PGXD
1
2
1 2
5
3
6
FP1
FP2
FP3
3
FP5 Receiver
① Power LED
Green
Power on
Yellow
Low battery alert
Red
Critical low battery, replace immediately
Flashing red on
power up
Battery dead
② RF LED
Illuminates when successfully synced to a transmitter (or manually
tuned to a transmitter's frequency)
③ Power Button
Press and hold to power on or off.
④ Infrared (IR) port
Sends infrared beam to synchronize frequencies.
⑤ TA3M Jack
Use with TA3F cable for audio out.
⑥ Audio Output Gain
Adjust audio output level to devices such as cameras or recorders.
⑦ LCD Screen
Displays current settings for GROUP and CHANNEL and battery life.
⑧ Scan Button
Group scan: Push and hold (3 sec.) to find an open group and channel.
Channel scan: Push and release to find an open channel in the current
Channel scan: Push and release to find an open channel in the current
group.
⑨ Sync button
Align receiver and transmitter and press sync. Blue IR LED indicates
successful sync.
Note: Press sync and scan buttons to manually enter group and chan-
nel numbers
⑩ Antennas
Two antennas for diversity reception.
Transmitter Controls and Connectors
① Indicator LED
Green
Ready
Flashing green
Controls locked
Flashing red
IR transmission in progress
Solid red
Battery power low
Flashing red on
startup
Batteries dead (transmitter cannot be turned
on until batteries are changed)
Rapic flashing
red after
synchronization
Transmitter and receive incompatible; contact
your Shure reseller
② Power Button
Press and hold to power on or off.
③ Infrared (IR) Port
Receives infrared beam to synchronize frequencies. When using
multiple systems, only one transmitter IR port should be exposed at a
time.
④ 4-Pin Microphone Input Jack
Use with with a TA4F connector for a lavalier or headset microphone.
⑤ Audio Input Gain
Adjusts audio level.
⑥ XLR Connection (FP3 only)
Plug into an XLR microphone or the output of an audio device.
⑦ Audio Input Level Indicator (FP3 only)
Red
Signal clip
Yellow
Nominal peak
Green
Audio present
7