Shure UR1HA User Manual

UR1H Bodypack Transmitter

Addendum

27A11915 (Rev. 2)

Printed in U.S.A.

Specifications:
The following specifications apply
to the UR1H bodypack only.

Features

High RF power (250 mW)

•

Same audio performance as UR1

•

Operates with alkaline or lithium batteries

•

Rapid, two-way infrared (IR) data transmission

•

External DC power connection

•

Optional remote mount antenna

•

Belt clip

•

Warning: The UR1H belt clip must be installed as shown to ensure
compliance with FCC RF exposure guidelines for safe use.
Safety Information

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. This equipment is in direct contact with the

body of the user under normal operating conditions. This transmitter must

not be co-located or operating in conjunction with any other antenna or

transmitter.
For body-worn operation, the UR1H has been tested and meets the

guidelines for safe use when used properly with the belt clip supplied or

designated by Shure for use with this product. For safe use, do not remove

or alter the position at the belt clip other than as instructed.

Frequency Range

Band

Range

H4, H4E

518-578 MHz

578-608, 614-638 MHz

J5E

578-638 MHz

L3E, L3

638-698 MHz

740-814 MHz

790-862 MHz

944-952 MHz

RF Carrier Frequency Range

518-862 MHz, depending on region

RF Output Power

250 mW (24 dBm) across all tunable frequencies,
maximum variation of -1.5 dB

Power Requirements

Two 1.5V AA batteries or

9 - 20 VDC, Shure PS22 adaptor recommended

Plug size: 1.7 mm x 4.0 mm (.067 in. x .159 in)

NOTE: This equipment has been tested and found to comply

with the limits of a Class B digital device when used with PS22,

pursuant to Part 15 of the FCC Rules.

Current Drain: 350 mA maximum at the battery terminals with

3 VDC applied

Battery Life (Typical): 3 hours, with 1.5V AA alkaline batteries

7 to 9 hours, with AA lithium primary batteries

Overall Dimensions

UR1H: 98 mm L x 60 mm W x 17 mm D

(3.84 x 2.38 x 0.66 in.)

Net Weight

97 g (3.4 oz.) without batteries

UR1H Transmitter RF Output

Connector:

SMA

Actual Impedance:

50 Ω

Pin Assignments:

Shell = Ground

Center = Signal

UR1H Transmitter Audio Input

Connector:

4-Pin male mini connector (TA4M)

Input Configuration:

Unbalanced, active

Actual Impedance:

>1 MΩ

Maximum Input Level:
(1 kHz, 1% THD)

+10 dBu (sensitivity 0 dB) +20 dBu

(sensitivity –10 dB)

TA4M Connector
Pin Assignments:

Pin 1: Ground

Pin 2: +5 VDC bias

Pin 3: Audio

Pin 4: Tied through active load (on main

board) to Ground

(On instrument adapter cable, Pin 4

floats)

REPLACEMENT PARTS AND ACCESSORIES
Furnished Accessories

Antenna, 518-578 MHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UA710

Antenna, 578-698 MHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UA720

Antenna, 740-865 MHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UA730

Threaded Locking Adaptor TA4F . . . . . . . . . . . . . . . . . . . . . . WA340
Optional Accessories

Bodypack Pouch (Black) . . . . . . . . . . . . . . . . . . . . . . . . . . . . WA580B

Bodypack Pouch (White) . . . . . . . . . . . . . . . . . . . . . . . . . . . . WA580W

AC to DC Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . PS22
Antenna Accessories

Note: SMA to adaptor (UA910) is required to connect the following

antenna accessories:

Antenna, 944-952 MHz

UA740

Passive Directional Wideband Antenna
(470-1100 MHz)

UA860SWB

2 ft. Coaxial Antenna Cable, BNC-BNC (RG58C/U)

UA802

6 ft. Coaxial Antenna Cable, BNC-BNC (RG58C/U)

UA806

25 ft. Coaxial Antenna Cable, BNC-BNC (RG8X/U)

UA825

50 ft. Coaxial Antenna Cable, BNC-BNC (RG8X/U)

UA850

100 ft. Coaxial Antenna Cable, BNC-BNC (RG213/U) UA8100
SMA to BNC Adaptor

UA910

UR1H