Checkpoint Systems Inc. FX2012 User Manual
NGL FX Installation Manual
Rev. *
47 of 84
6. Click Apply. Figure 27X*** shows the switch setting parameters under the Tuning tab.
Figure 25X*** Tuning Settings
7. Under the Band Tab, fill in the following parameters:
•
Frequency Band
: Set to the application required by the customer. For more
information about the choices, refer to ***"Application-Based Detection
Modes" section in this document.
Modes" section in this document.
•
Edge Blanking
: Set to 0-15.
•
Master/Submaster
: Set to "Master" for any Single-Aisle System. For Multi-
Aisle Systems, refer to the "Multi-Aisle Setup" section below for the appropriate
setting.
setting.
•
Q Band Detection
: Choose a setting based on the type of tags used by the
customer (Hard tag, 410, etc.).
•
Threshold Adjust
: Set to either 16 or 0.
8. Click on Apply. Figure 28X*** shows the Band tab parameters for NGL. ***
Figure 26X*** Band Settings