Checkpoint Systems Inc. LIB24TZ User Manual
Classic Street Installation Manual
Rev. *60
19 of 28
Figure 11 Single Aisle
Secondary antenna (SSB) wiring
Step 1: Open the base cover.
Step 2: Plug the pre-terminated RG59 coax cable onto coupler board J5, then mount two (2)
ferrite clippers close to the connector (see Figure 7 RG 59 Coax cable wiring diagram).
Note: It is recommended to leave the pre-terminated coax cable end at SSB location where the
cable was laid out.
Step 3: Connect the SSB Lights/Sounder cable to the wire terminal LT+ (White) / LT- (Green)
and SD+ (Red)/SD- (Black) resp.
Step 4: Inspect wiring and connections, confirm coupler board jumper settings (see Figure 12
SSB Coupler Board Jumper Settings).
Step 5: Put the base cover back and secure.