Schneider Electric Buildings LLC WIRELESS User Manual
Installation Instructions
Wireless Adapter/Repeater
© 2006 TAC / Tour Andover Controls, Inc., all rights reserved.
Introduction
TAC has designed a device that allows Andover Con-
tinuum controllers to communicate with other controllers
across a wireless field bus mesh network. The Andover
Continuum Wireless Adapter/Repeater is a single device
that can perform two roles — adapter and repeater.
As a
Wireless Adapter, the device is attached to the
service port of a controller and allows the controller
to communicate across a wireless mesh network with
other controllers. The Wireless Adapter replaces the
normal hard-wired network connection between control-
lers. Power to the Adapter is supplied by the controller,
through the service port.
As a
Wireless Repeater, the device is used to strength-
en the mesh network by providing redundant routes
to circumvent temporary or permanent obstructions. A
robust mesh network is able to self heal by dynamically
creating optimal routes. A Repeater may be needed
when there are long distances between wireless-en-
abled controllers, or to compensate for obstructions,
such as pipes or walls that can attenuate or weaken the
wireless signal between controllers.
When the device is used as a wireless repeater, it is not
connected to a controller, can be installed almost anywhere,
and only requires a power source to function.
i2/b3 Controller
i2/b3 Controller
i2/b3 Controller
i2/b3 Controller
i2/b3 Controller
bCX Controller
Wireless
Repeater
Repeater
Wireless
Repeater
Repeater
Wireless
Adapter
Adapter
Wireless
Adapter
Adapter
Wireless
Adapter
Adapter
Wireless
Adapter
Adapter
Wireless
Adapter
Adapter
Ethernet
Workstation
Wireless
Adapter
Adapter
.79
20
2.16
55
2.63
67
30-3001-887
Rev A