Uniden America Corporation ON525 User Manual

Page of 3
GMR3055-2CK
GMR3055-2CKHS
GMR3055-3VP
Congratulations on your purchase of a Uniden GMRS/FRS 
radio. This lightweight, palm-sized radio is a state-of-the-art 
device, equipped with many valuable features. Use it at 
sporting events, to stay in contact with family and friends, 
hiking, skiing, outdoors, or in a neighborhood watch for vital 
communication.
•  15 GMRS/7 FRS 
Channels
•  Battery Charging Cradle 
(GMR3055-2CK and 
GMR3055-2CKHS)
•  121 Privacy Codes
•  NOAA Emergency/Weather 
Channels
•  Up to 30-Mile 
Range*
•  Weather alert
•  Channel Scan
•  microUSB charging jack
•  VOX Headset Jack
•  10 Selectable Call Tone 
Alerts
•  Roger Beep
*  Range may vary depending on environmental and/or 
topographical conditions.
GMR3055 HARDWARE
1
2
3
4
5
6
7
8
10
11
9
1
Antenna
7
Speaker
2
USB Charge Port/ 
Headphone Jack
8
Channel and 
Volume 
3
Push to Talk
9
WX/LOCK
4
Microphone
10 CH/Backlight
5
MENU/Power
11
Screen
6
CALL/MON
WHAT'S IN THE BOX
 
All models come with:
•  2 radios (3 radios for GMR3055-3VP)
•  6 AA rechargeable NiMH batteries (9 NiMH 
batteries for GMR3055-3VP)
•  2 belt clips (3 belt clips for GMR3055-3VP)
•  This reference guide 
GMR3055-2CK also has:
•  1 battery charging cradle
•  1 AC adapter/single microUSB cable
GMR3055-2CKHS also has
•  1 battery recharging cradle
•  1 AC adapter/single microUSB cable
•  2 earbud-style headphones (GMR3055-
2CKHS
GMR3055-3VP also has:
•  1 AC adapter/Y-Split microUSB charge cable 
(GMR3055-3VP) 
Visit our web site at www.uniden.com to order 
accessories.
Use only Uniden accessories.
The radio operates on the General Mobile Radio 
Service (GMRS) frequencies which require a 
Federal Communications Commission license to 
operate. For licensing information and  
application forms, visit the FCC on-line at: www.
fcc.gov/wtb/uls or call the FCC  hotline at 1-800-
418-3676. If you have any questions you can 
contact the FCC direct at 1-888-225-5322.
Each radio uses 3 AA rechargeable NiMH 
batteries (included).
To install the batteries:
1.  If installed, remove the belt clip.
2.  Remove the battery compartment door by 
pressing on the latch and releasing the 
cover. Remove it.
3.  Install the supplied 3 NiMH batteries into 
the battery compartment. Be certain to 
follow the + and – symbols in the 
compartment. Installing the batteries 
incorrectly will prevent the unit from 
operating.
4.  Replace the battery compartment door.
5.  Replace the belt clip if necessary.
6.  Repeat for each radio.
Note: You may also use 3 AA non-rechargeable 
alkaline batteries in each radio. However, 
do not mix NiMH and alkaline batteries 
in the same radio.
FCC GMRS LICENSE
INSTALL THE BATTERIES
 
CHARGING THE RADIO
Review the following tips before charging your 
radios:
CAUTION:  Do not attempt to recharge 
alkaline batteries. Doing so can create 
a safety hazard or damage the radio.
•  Install the batteries before connecting the AC 
adapter to the radio and power source.
•  The battery icon flashes while the radio 
charges, whether the radio is turned on or not. 
The charge stops after 14 hours of continuous 
charging. If there is a power interruption, the 
charging timer resets to 14 hours. If the radio 
is off and charging stops, the battery icon 
stops flashing.
•  Charge time may vary depending on the 
battery life remaining. For fastest charging, 
turn off the radio before charging.
•  If battery power is low, you cannot operate the 
radio even using external power. If you try to 
transmit while power is low, the radio will 
automatically turn off. Recharge the batteries.
GMR3055-2CK, GMR3055-2CKHS
These models use a charging cradle (included) 
to charge their NiMH batteries. 
1.  Plug the charging cradle into an AC adapter 
and then plug the AC adapter into a power 
source (wall outlet). .
2.  Install the NiMH batteries in the radios.
3.  Place the radios in the charging cradle. The 
radios begin charging and the red LEDs 
turn on.
4.  The radio is fully charged when 
the red POWER LEDs go off.
GMR3055-3VP
This model charges through a microUSB 
Y-branch cable (included) with an AC adapter 
that plugs into an AC power source.
1.  Plug one branch of the microUSB Y-Cable 
into each radio's microUSB charge port. 
2.  Insert the AC adapter into an AC power 
source (wall plug).
3.  The radios are charged after 14 hours 
when the battery icon on the screen stops 
flashing.
Note: You will have to charge 2 of the 3 radios 
and then charge the last one.
USING THE RADIO
Turning the Radio On and Adjusting the 
Volume
1.  Press and hold the MENU/
 
key to turn 
the radio ON.
2.  To change the volume level, press the 
 or 
 key to increase or decrease the 
volume level. There are 8 volume levels (L1 
L8) plus volume off (L0)
3.  Press and hold the MENU/
 key to turn 
the radio OFF.
Using Headphones
The GMR3055-2CKHS radio comes with earbud 
headphones for each radio. You can purchase 
optional earbuds or headsets for other radios if 
desired. See www.uniden.com to purchase 
authentic Uniden products.
Using the earbuds lets you have more private 
communications. To use the earbuds, lift the 
rubber cover from the headset jack, then plug in 
the earbuds. The microphone is on the earbud 
cable.
Important: Your radio is not weather resistant 
when using a headset jack. When you remove 
the earbuds, be sure to fully press the cover into 
place to restore its weather resistant capability.
Using the Menu
Press MENU/
 
to access the three menu 
options:
•  Privacy Code (121 codes). The privacy codes 
display underneath the channel number on 
the screen.
•  Call Tone (10 call tone options plus Off)
•  VOX (5 levels plus Off) 
Each menu option is discussed later in the 
manual with the feature that uses it.
Choosing a Channel
Your radio has 22 channels you can use to talk 
to others. In order to speak to someone, each of 
you must be set to the same channel and 
privacy code.
Each of the channels 1-22 may have any one of 
the privacy codes, 0 (OFF), or 1-121 selected. 
Code oF (OFF) indicates no privacy code 
selected and your radio can receive a signal 
regardless of the code settings of the 
transmitting radio.
To choose a privacy code:
1.  Press MENU/
 
until the privacy code 
number flashes below the channel number.
2.  Press ▲ or ▼ to cycle through the privacy 
codes. 
3.  The radio returns to its normal state after 
about 10 seconds.
To choose a channel:
1.  Press the CH/
 key to access the channel 
function; the channel number flashes.
2.  Press ▲ or ▼ to manually cycle through
the channels. 
You can only manually cycle through channels 
when the channel numbers are flashing.
3.  Press CH/  to set the channel.
VOX Feature
CAUTION:  Insert headphones into the radio 
BEFORE turning on the radio. 
Your radio is equipped with a user selectable Voice 
Operated Transmitter (VOX) that can be used for 
automatic voice transmissions. The VOX feature is 
designed to be used with or without a headset with a 
microphone. Transmission is initiated by speaking into 
the microphone instead of pressing PTT.
To select a VOX level:
1.  Press 
MENU
 repeatedly until the vox icon and 
the VOX sensitivity level (OFF, 1-5) blink.
2.  Press 
▲ or ▼ to change the VOX sensitivity 
levels. Use level 5 for increased sensitivity to 
voice in normally quiet environments, and use a 
lower level to reduce undesired activation in very 
noisy environments.
3.  The radio returns to its normal state after about 
10 seconds.
Channel Scan Feature
Your radio has a channel scan feature that allows you to 
easily scan all 22 channels. When an active channel is 
detected, the unit pauses on that channel until the 
channel is clear. Then, after a 2 second delay, the radio 
continues scanning. Press CH/
 
to resume scanning 
while the radio is stopped on an active channel. 
When the unit stops on an active channel, you can 
press the PTT button to transmit on that channel.
Using channel scan
Press CH/  then hold ▼ or ▲ for 3 seconds. The
radio will repeatedly cycle through all 22 channels. To 
reverse scan direction, press the other directional icon. 
Press MENU/  or CALL/MON to stop scanning. Press  
CH/
to resume scanning in the same direction it was 
scanning previously.
Silent Mode
Silent mode turns off all key beeps when it is turned on. 
It does NOT mute call or voice signals received. 
Change Silent mode status (OFF or ON) by first turning 
OFF the radio. 
•  To turn Silent mode off, press and hold the MENU/
 
key to turn the radio ON. Silent mode is off and 
key beeps sound. (Default)
•  To turn Silent mode on, press and hold the CALL/
MON
 and MENU/  keys to turn the radio back ON. 
Silent mode turns on and no key beeps sound.
Talking on Your Radio
When the radio stops on a channel that is transmitting, 
you can talk to others on that channel. 
 
Transmitting
1.  Press and hold the PTT button and speak in a 
clear, normal voice about 2-3 inches away from