Uniden America Corporation UC518 User Manual

Page of 38
50
Using the 
Answering 
System
To operate from a remote location, use any touch-tone telephone, and follow these steps:
Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after 
about ten rings and sounds a series of beeps.
During the greeting or the beeps (if answering system is off), press [0] and enter your security code/PIN within 
two seconds.
The answering system announces the current time and the number of messages stored in memory.
You hear “To play incoming messages, press zero-two. For help, press one-zero” followed by a beep.
Enter a remote command from the chart below. You have fi fteen seconds to enter the fi rst command; after the 
fi rst command, you have two seconds to enter each command.
If you want to
Press
If you want to
Press
Play incoming 
messages
[0] then [2] 
The answering system plays back 
messages for four minutes, then 
waits for another command. To 
continue playing your messages, 
press [0] then [2] again.
Stop the current operation to 
enter a different command.
[0] then [5]
Repeat this message  [0] then [1] (after the fi rst four 
seconds of this message)
Turn the answering system off
[0] then [9]
Go back to the 
previous message
[0] then [1] during the fi rst four 
seconds of a message 
Turn the answering system on
[0] then [6]
Skip this message
[0] then [3]
Listen to the help prompts
[1] then [0]
Delete this message
[0] then [4]
Exit the system
Hang up.
When you fi nish, you will hear intermittent beeps indicating that the system is in the command waiting mode. 
Enter another command from the chart within fi fteen seconds.
Hang up to exit the system. The answering system automatically returns to its normal standby setting.
1)
2)
3)
4)
5)
6)
UP883BH(TRU9565-2) book OM 2.ind50   50
UP883BH(TRU9565-2) book OM 2.ind50   50
12/27/2007   4:37:21 PM
12/27/2007   4:37:21 PM