Enlighted Inc. PC-01-20 User Manual
Page 5
Page 6
Page 1
Copyright © 2014 Enlighted Inc. All rights reserved.
All other brand or product names are trademarks of
their respective companies or organizations.
Technical Support
For questions regarding the installation or operation of
this product, contact Enlighted
Technical Support: support@enlightedinc.com
Company Contact Information
Location: 930 Benecia Ave, Sunnyvale, CA 94085
Phone: +1.650.964.1094
Web: enlightedinc.com
CA Contractor’s License: CCL# 980903
FCC and Industry Canada Compliance Information
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense.
USA
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
•
this device may not cause harmful interference, AND
•
this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by Enlighted Inc.
could void the user's authority to operate the equipment.
Canada
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
•
this device may not cause harmful interference, AND
•
this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by Enlighted Inc.
could void the user's authority to operate the equipment.
Le présent appareil est conforme aux CNR d'Industrie Canada
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes:
•
l'appareil ne doit pas produire de brouillage, ET
•
l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
CE
This device complies with the essential requirements and other
relevant requirements of the R&TTE Directive (1999/5/EC). The
product is compliant with the following standards and/or other
normative documents. EN 62479, ETSI EN 301, EN 300
•
The equipment is Class 1 radio equipment which can be placed
on the market and be put into service without restrictions in
accordance with article 1(3) of Commission Decision 2000/299/EC
(Version July 2014).
Figure 1: Plug Load Controller, Locknut, and Sticker
Plug Load Controller
Model PC-01-20
Installation Instructions
Shipped Components
•
Plug load controller (and ½ inch locknut)
•
MAC address sticker
Tools You May Need
•
Wire stripper
Supplies You May Need
•
Wire nuts (or connectors)
•
Junction box (j-box)
•
2 Conductor plus ground 12 AWG solid wire cable
•
3 Conductor plus ground 12 AWG solid wire cable
•
Clamps
93-01142-01 Rev02
Model: PC-01-20
FCC ID: AQQ-PC-01-20
Industry Canada: 10138A-PC0120