E F Johnson Company 2425M70 User Manual
6-10
Conventional Features
1 If required, select a channel of a system on which Emergency Calls are enabled and
press the EMER option switch. The Emergency Call is then sent as described in Section
6.9.1 if applicable.
6.9.1 if applicable.
2 If the preceding Emergency Hot Mic feature is enabled, the call is automatically
transmitted without pressing the PTT switch. If it is disabled, press the PTT switch and
begin speaking as with a standard call. If the channel is changed, operation continues on
the new channel in the emergency mode.
begin speaking as with a standard call. If the channel is changed, operation continues on
the new channel in the emergency mode.
3 With analog calls, subsequent presses of the PTT switch cause the DTMF emergency
ID to be sent according to the ANI programming (if DTMF ANI is enabled on the
channel). With digital calls, the calls continue to have the emergency bit set.
channel). With digital calls, the calls continue to have the emergency bit set.
4 If the Surveillance Mode is enabled (see Section 5.10), all indicators, lights, and tones
are disabled. If “No Receive Activity During Emergency” is programmed, receive
audio, the front panel LED, and receive icons are disabled in the receive mode.
audio, the front panel LED, and receive icons are disabled in the receive mode.
5 To exit this mode, cycle radio power or press and hold the Emergency switch.
6.10
Conventional Mode Channel Scanning
Channel scanning features common to all operating modes are described in Sections 5.12
and 5.13. The following information describes features unique to conventional operation.
and 5.13. The following information describes features unique to conventional operation.
6.10.1 Selecting a Scan List
Conventional systems are programmed with a default scan list that is normally selected by
all channels in that system. However, there is a programmable option to slave a particular
conventional scan list to a zone. This then becomes the default list for all conventional
channels in that zone (it overrides the system programming). This slave feature is
programmed on the Edit Zone screen.
all channels in that system. However, there is a programmable option to slave a particular
conventional scan list to a zone. This then becomes the default list for all conventional
channels in that zone (it overrides the system programming). This slave feature is
programmed on the Edit Zone screen.
The default scan list (which is to be used by all conventional channels except those
belonging to slaved zones), can be temporarily changed by using the SCAN option switch
or menu parameters. A scan list selected in this manner is retained through radio power
down.
belonging to slaved zones), can be temporarily changed by using the SCAN option switch
or menu parameters. A scan list selected in this manner is retained through radio power
down.
6.10.1.1
Conventional Scan List Select Procedure
The scan list select procedure is as follows:
Draft 4/29/2014