Motorola Solutions Inc. 89FT7003 User Manual

The information provided in this document supersedes information contained in user 
guides published prior to February 2003.  

For radio terminals that have been approved as intrinsically safe, read the instruc-
tions and information on intrinsic safety in this booklet.

Notice: This radio terminal is intended for use in occupational/controlled applica-
tions, where users have been made aware of the potential for exposure and can ex-
ercise control over their exposure. This radio terminal device is NOT authorized for 
general population, consumer or similar use. 

The FCC established limits for safe exposure to radio frequency (RF) emissions 
from portable two-way radios. The FCC requires manufacturers to demonstrate 
compliance with RF exposure limits before portable two-way radios can be market-
ed in the U.S. When two-way radios are approved for occupational /controlled envi-
ronment exposure limits, the FCC requires users to be fully aware of and exercise 
control over their exposure. Awareness and control of RF exposure can be accom-
plished by the use of labels,  or by education or training through appropriate means, 
such as information and instructions in user manuals or safety booklets. This user 
safety booklet includes useful information about RF exposure and helpful instruc-

tions on how to control your RF exposures.  

Your Motorola two-way radio terminal is designed and tested to comply with a num-
ber of national and international standards and guidelines (listed below) regarding 
human exposure to radio frequency electromagnetic energy. This radio terminal 
complies with the IEEE (FCC) and ICNIRP exposure limits for occupational/con-
trolled RF exposure environment. In terms of measuring RF energy for compliance 
with the FCC exposure guidelines, your radio terminal radiates measurable RF en-
ergy only while it is transmitting, not when it is receiving or in standby mode. 

• United States Federal Communications Commission, Code of Federal Regula-

tions; 47CFR part 2 sub-part J

• American National Standards Institute (ANSI) / Institute of Electrical and Elec-

tronic Engineers (IEEE) C95. 1-1992

• Institute of Electrical and Electronic Engineers (IEEE) C95.1-1999 Edition
• International Commission on Non-Ionizing Radiation Protection (ICNIRP) 

1998

• Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure to 

Radio frequency Electromagnetic Fields in the Frequency Range from 3 kHz 
to 300 GHz, 1999

• Australian Communications Authority Radio communications (Electromagnetic 

Radiation - Human Exposure) Standard 2001. 

• ANATEL, Brasil Regulatory Authority, Resolution 256 (April 11, 2001) "addi-

tional requirements for SMR, cellular and PCS product certification."

To control your exposure and ensure compliance with the occupational /controlled 
environment exposure limits always adhere to the following Procedures.

• If  you are not using a body-worn accessory and are not using the radio termi-

nal in the intended use position in the hand, then ensure the antenna and the 
radio terminal are kept 2.5 cm (one inch) from the body when in use. Keeping 
the radio terminal at a proper distance is important because of RF exposures 
decrease with distance from the antenna. 

• Use only Motorola approved supplied or replacement batteries, and accesso-

ries. Use of non-Motorola-approved, batteries and accessories may exceed 
FCC RF exposure guidelines. 

For additional information on RF exposure awareness information, visit the following 
Motorola website: www.mot.com/rfhealth.

ab