Futaba Corporation FDP03 User Manual

INSTRUCTIONS MANUAL 
FEDERAL COMMUNICATIONS COMMISSION 
INTERFERENCE STATEMENT

 

 
 
 
This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules.    These limits are designed to provide 
reasonable protection against harmful interference in a residential installation.  This 
equipment generates, uses, and can radiate radio frequency energy and, if not installed 
and used according to the instructions, may cause harmful interference to radio 
communications.    However, there is no guarantee that interference will not occur in a 
particular installation.    If this equipment does cause harmful interference to radio or 
television reception, which it found by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures: 
 
 
-- Reorient or relocate the receiving antenna. 
-- Increase the separation between the equipment and receiver. 
-- Connect the equipment into an outlet other than the receiver’s 
-- Consult the dealer or an experienced radio/TV technician for assistance. 
 
 
 
CAUTION:  
 
To assure continued FCC compliance:          
(1) Any changes or modifications not expressly approved by the grantee of this device 

could void the user's authority to operate the equipment. 

 
FCC Label Compliance Statement: 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and (2) 
this device must accept any interference received, including interference that may 
cause undesired operation. 
 
Exposure to Radio Frequency Radiation
To comply with FCC RF exposure compliance requirements, a separation distance of at
least 20cm must be maintained between the antenna of this device and all persons.  This
device must not be co-located or operating in conjunction with any other antenna or 
transmitter.