UTC Fire & Security Americas Corporation Inc 612-H20PANIC User Manual

P/N 46-667 • REV J •23APR14 

1 

 

Learn Mode Water Resistant Pendant Panic 
Button Installation Instructions 

This panic button can be used throughout the premises for 

police, medical, or auxiliary alarm activation. When the sensor 

button is pressed, the built-in transmitter sends a signal to the 

panel (Figure 1 below). 

 

The water-resistant design helps prevent damage in case the 

sensor accidently gets wet. 

The sensor can be worn using the built-in belt clip or it can be 

mounted on a wall in a location convenient for the customer, 

using the optional wall-mount holder (kit number 80-116). Each 

kit includes the following: 

• 5 

wall-mount 

holders; 

• 

5 pieces of double-sided tape; 

• 

10 plastic anchors; and 

• 

10 Phillips-head screws. 

You will also need a small Phillips screwdriver (if installing the 

optional wall-mount holder). 

Use the following guidelines when installing this button: 

• 

The transmitter in the button has an open-air range of up 

to 1,000 ft. (305 m), but the installation environment may 

influence this range. 

• 

When mounting on a wall, determine the best location for 

each panic button so it is easily accessible. 

• 

The 3.5 VDC lithium battery will last at least 12 months. 

You can mount the optional wall-mount holder, using anchors 

and screws or double-sided tape. 

1.  Place the holder on the wall at the desired location and 

mark the mounting holes with a pencil (Figure 2 below). 

Mounting hole

Mounting hole

 

2.  Secure the holder to the wall with the screws supplied. 

Use the anchors supplied where studs are not present. 

1.  Peel off the colored backing from the double-sided tape 

and place it on back of the holder (Figure 3 below). 

Affix

tape
here

 

2.  Peel off the other backing and firmly press the holder 

against the mounting surface.