Bosch Security Systems Inc. M514 User Manual
BTR-800 Users Manual Page 2
pre-programmed frequency sets or each base can be programmed to special
frequencies by the user.
The BTR-800 has a built-in 100 to 240 VAC 50/60 Hz power supply.
Power is controlled by the ON/OFF front panel switch.
Half (1/2) Wave antennas are supplied with the base station.
These antennas are ground independent. For improved range distance), Log
Periodic Antennas and various lengths of coaxial cable with connectors are
available as accessories.
Transmit (RF) power is switchable on the rear panel from 100mW
(maximum) to 10 mW (minimum). The transmit power can also be turned
off for use in multi systems where only one set of master transmitters is
desired. The low power setting can be useful where multi-system intermod
could occur or when it is desired to reduce the base transmitter range.
An Intercom (I/C) termination switch on the rear panel allows selecting
Telex, RTS or ClearCom connections.
Both Intercom A and B have XLR and RJ Connectors on the rear panel in
order to “Loop-Thru” to inter-connect several bases together.
The Auxilliary Audio Input and Output connectors are “one way” ports
that are useful for stand-alone applications.
The Stage Announce is an Audio Output useful for any announce or page
application . There is a dry “Relay Contact” (N.O.) also available on the
rear panel for switching applications when stage announce is activated.
END
pre-programmed frequency sets or each base can be programmed to special
frequencies by the user.
The BTR-800 has a built-in 100 to 240 VAC 50/60 Hz power supply.
Power is controlled by the ON/OFF front panel switch.
Half (1/2) Wave antennas are supplied with the base station.
These antennas are ground independent. For improved range distance), Log
Periodic Antennas and various lengths of coaxial cable with connectors are
available as accessories.
Transmit (RF) power is switchable on the rear panel from 100mW
(maximum) to 10 mW (minimum). The transmit power can also be turned
off for use in multi systems where only one set of master transmitters is
desired. The low power setting can be useful where multi-system intermod
could occur or when it is desired to reduce the base transmitter range.
An Intercom (I/C) termination switch on the rear panel allows selecting
Telex, RTS or ClearCom connections.
Both Intercom A and B have XLR and RJ Connectors on the rear panel in
order to “Loop-Thru” to inter-connect several bases together.
The Auxilliary Audio Input and Output connectors are “one way” ports
that are useful for stand-alone applications.
The Stage Announce is an Audio Output useful for any announce or page
application . There is a dry “Relay Contact” (N.O.) also available on the
rear panel for switching applications when stage announce is activated.
END