HP SDCAB0705 User Manual

Page of 62
Industry Canada ICES-003 Emission Compliance Statement
This Class B digital apparatus meets the requirement of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du règlement sur le matériel
brouiller du Canada.
Canadian Radio Standards
This device meets the requirements of the Canadian Radio Standards Specifications RSS-210.
Cet appareil respecte toutes les exigences du cahier des charges sur les normes radioélectriques
CNR-210 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of this device.
L ‘ utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas
produire de brouillage et (2) l’ utilisateur du dispositif doit étre prêt à accepter tout brouillage
radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du
dispositif.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for
successful communication.
Pour réduire les possibles interférences radio pour les autres utilisateurs, le type d'antenne et sa
gaine doivent être choisis de sorte que la puissance isotrope rayonnée équivalente (PIRE) n'excède
pas ce qui est nécessaire pour une communication réussie.
To prevent radio interference to the licensed service, this device is intended to be operated indoors
and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is
installed outdoors is subject to licensing.
Pour empecher que cet appareil cause du brouillage au service faisant l'objet d'une licence, il doit
etre utilize a l'interieur et devrait etre place loin des fenetres afin de Fournier un ecram de blindage
maximal. Si le matriel (ou son antenne d'emission) est installe a l'exterieur, il doit faire l'objet d'une
licence.
Exposure to Radio Frequency Radiation
The radiated output power of the Opal Bluetooth wireless radio Class 2 is far below the FCC, Industry
Canada and European Union radio frequency exposure limits. Nevertheless, the wireless radio shall
be used in such a manner that the potential for human contact during normal operation is minimized.
The internal wireless radio operates within guidelines found in radio frequency safety standards and
recommendations, which reflect the consensus of the scientific community.
The level of emitted energy emitted is far less than the electromagnetic energy emitted by wireless
devices such as mobile phones. However, the use of wireless radios may be restricted in some
situations or environments, such as aboard airplanes. If you are unsure of restrictions, you are
encouraged to ask for authorization before turning on the wireless radio. The FCC, Industry Canada
and European Union have set a general guideline of 20 cm (8 inches) from the body when wireless
devices are on.
Canada: The installer of this radio equipment must ensure that the antenna is located or pointed
such that it does not emit RF field in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada’s website 
.
Notice to users in the European Economic Area
Hereby, Hewlett-Packard Co., declares that this equipment complies with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
Chapter 4
54
Technical information