Andrew Wireless Innovations Group RPT-MOR701 User Manual
User’s manual for Remote Unit MOR701B Power
M0069A0A.doc
Id.-No 151154
Page 46
23-June-99
6.2.2 Power connection
Before connecting electrical power to the Repeater grounding has to be performed. The
Repeater is equipped with a firmly connected power cord. Due to safety reasons the power
supply lead of the Repeater has to be protected with two 8 A fuses, type MT. In the event the
length of the power cord should not be sufficient it can be replaced by a longer cable.
Repeater is equipped with a firmly connected power cord. Due to safety reasons the power
supply lead of the Repeater has to be protected with two 8 A fuses, type MT. In the event the
length of the power cord should not be sufficient it can be replaced by a longer cable.
figure 6-5 Screw terminal
F
Note:
If the power supply lead has to be replaced use a cable of the same quality.
6.2.3 Connection of the antenna cable
The Repeater has a female antenna connector 7/16 (or N with adapter). For mounting the
corresponding cable connector we recommend to refer to the applicable documentation of the
respective connector manufacturer. The bending radius of the antenna cable must remain
within its specification. This will warrant proper operation of the system; otherwise changes
in the electrical behaviour of the cable might occur which could cause malfunction of the
Repeater system.
corresponding cable connector we recommend to refer to the applicable documentation of the
respective connector manufacturer. The bending radius of the antenna cable must remain
within its specification. This will warrant proper operation of the system; otherwise changes
in the electrical behaviour of the cable might occur which could cause malfunction of the
Repeater system.
F
Note:
It is sufficient to fix the 7/16 (or N) antenna connector hand-screwed.
Any use of a tool (like tongs) might cause damage to the connector and
thus lead to malfunctioning of the Repeater.
Any use of a tool (like tongs) might cause damage to the connector and
thus lead to malfunctioning of the Repeater.