Andrew Wireless Innovations Group RPT-MR701 User Manual
User’s manual for Repeater MR801B Power
M0067A0A.doc
Id.-No 151111
Page 64
02-JUNE-99
The power supply is fixed to the Repeater housing by means of two special nuts M4. After
loosen the screws the power supply can be removed. To open these screws a special key with
a spherical head is required. Place a small screwdriver between the Repeater housing and the
power supply to loose the device.
loosen the screws the power supply can be removed. To open these screws a special key with
a spherical head is required. Place a small screwdriver between the Repeater housing and the
power supply to loose the device.
figure 9-13 Position of special-nut M4
F
Note:
Don’t forget to put heat conducting paste on the mounting side for
installation of a new power supply. Use the conducting paste, which is
included in the spare parts kit.
installation of a new power supply. Use the conducting paste, which is
included in the spare parts kit.
9.11 Replacement of active combiner modules
The active combiner modules are mounted on both sides of the Repeater.
Disconnect all SMA connectors by means of a torque wrench.
Unscrew two counter sunk screws M3x20mm. See figure 9-14 Position of counter sunk
screws on active combiner
screws on active combiner