Andrew Wireless Innovations Group RPT-MR703P User Manual
U
SER
´
S MANUAL FOR BAND SELECTIVE REPEATERS
MR
X
03P
User'sManual.doc
Id.-No.:154999
Page 23
22-Jan-01
4. INSTALLATION
4.1.
MECHANICAL INSTALLATION
4.1.1. General
F
Note:
Due to power dissipation the repeater may reach a very high
temperature. Therefore, it is necessary to mount the repeater
vertically to a wall or a mast without additional enclosure. A
clearance distance of one metre above and below the unit should be
kept to provide sufficient ventilation. Between the housing and the
wall, a minimum distance of 20 mm must be ensured.
temperature. Therefore, it is necessary to mount the repeater
vertically to a wall or a mast without additional enclosure. A
clearance distance of one metre above and below the unit should be
kept to provide sufficient ventilation. Between the housing and the
wall, a minimum distance of 20 mm must be ensured.
F
Note: The weight of the repeater is
approximately 14 kg in standard
configuration. Only adequate
manpower is allowed to handle
the weight of the system.
configuration. Only adequate
manpower is allowed to handle
the weight of the system.
F
Note: If it is impossible to mount the
repeater with the mounting
brackets due to an uneven
surface (e.g. a bulged wall in a
tunnel), alternative fastening
devices may be used. These
fastening devices must fulfil the
following requirements:
brackets due to an uneven
surface (e.g. a bulged wall in a
tunnel), alternative fastening
devices may be used. These
fastening devices must fulfil the
following requirements:
F
Note: The external strain must not be
increased by the alternative fastening
devices. Holding devices, which expose
the repeater to enhanced vibration or shock
due to a greater distance from the wall (leverage)
or due to a lower rigidness or
devices. Holding devices, which expose
the repeater to enhanced vibration or shock
due to a greater distance from the wall (leverage)
or due to a lower rigidness or
stability
(vibration), must not be used.
F
Note: The repeater’s external strain specifications must not be exceeded,
particularly the exposure to vibration and shock (please refer to the
MIKOM “Environmental and Safety Leaflet” for further detailed
information).
MIKOM “Environmental and Safety Leaflet” for further detailed
information).
F
Note: Exceeding the specified load limits may cause the loss of warranty!