Unit Connection Technology Co. Ltd WS015T User Manual
FT015T
Outdoor Thermometer
User Manual
1. Introduction
Thank you for your purchase of the FT015T
wireless outdoor Thermometer. The following user
guide provides step by step instructions for installation, operation and troubleshooting.
2. Getting Started
The FT015T
wireless indoor / outdoor thermo-hygrometer consists of a display console (receiver),
and a wireless thermo-hygrometer (remote transmitter).
2.1 Parts List
QTY
Item
1
Thermo-Hygrometer transmitter
Dimensions (LxWxH):6.8 x5.0 x 2.0cm
1
User Manual
2.2 Remote Thermo-Hygrometer Sensor Set Up
Note: To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
Pull down on the battery door to open the battery compartment, as shown in Figure 1.2. Insert two
fresh AAA batteries (with the negative terminal of the battery in contact with each spring). Lithium
batteries are recommended for cold weather environments. Slide the top lip of the battery door into the
battery compartment guide and snap the bottom battery door bracket into place. The LED shown in
Figure 1.1 will light up (visible through the plastic).
Figure 1
2.4 Sensor Operation Verification
Verify the humidity sensors match closely with the console and the sensors are in the same location
(about 1-3 meters apart). The sensors should agree within 10% (the accuracy is ± 5%). Allow about
30 minutes for all sensors to stabilize. The humidity can be adjusted or calibrated later to match each
other a known source.
Verify the temperature sensors match closely with the console and sensor array in the same location
(about 1-3 meters apart). The sensors should be within 2°C (the accuracy is ± 1°C). Allow about 30
minutes for all sensors to stabilize. The temperature can be adjusted or calibrated later to match each
other or a known source.