GuangZhou SunFieldAimo Electronic Technology Co. Ltd XYAM User Manual

Setting Up the Controller

Turn on the remote control power switch and plug in the motor. Once both are 

on hold (SET) + (POWER) for 3 seconds. The motor light will stop blinking, and 

the gear will shudder. This means that the controller and motor have been 

successfully synchronized. (Note: This process is usually done before leaving 

the factory.)

1) Before installing the drive onto the lens, please make sure the wireless 

remote controller and motor are powered on and connected. DO NOT turn the 

wireless remote control dial, put the drive gear close to the lens ring and 

tighten the screws.The controller can automatically locate the start and end points 

of any lens. To calibrate your lens, hold the (SET) + (A) button on the remote 

controller for 3 seconds.

Rotate the focus ring clockwise to the end; hold (SET) + (REC) + (POWER)

buttons together for 3 seconds. Rotate to the opposite end and press the three 

buttons again

Press (POWER) quickly to toggle marker light ON or OFF.

To change screen brightness, press and hold (SPEED) + (A), (B), (C), or (D), 

(SPEED) + (A) being the lowest brightness level, (SPEED) + (D) being the

highest brightness level.

3

The controls have been designed for ease of use: They allow for preset 

memory points, where you can save up to four, as well as two lock points

that will cause the controller to vibrate as you approach them. Choose from 16 

different speed levels to control the transition speed of the presets, and 4 different 

damping levels from ultraresponsive to ultra smooth. The controller has an accuracy 

circuit built into it to ensure the lens stop precisely where you want it to, even after 

repeated use.